ELECTRICAL CONNECTION
Make sure the appliance is installed a The appliance mustnd be connected to the
connected to the electricity supply by a electricity supply by means of an all-pole
qualified technician in accordance with disconnect switch with minimum contact
the manufacturer?s instructions and in gap of 3 mm.
compliance with local regulations. The appliances must be earthed by law.
The installer is responsible for the correct
electrical connection of the appliances Do not use multiple plug adapters or
extension leads.
and the observance of the relative safety After the oven has been installed, the
recommendations.
electrical components must be
concealed.
Connecting the oven to the power supply
Make sure that the voltage shown on the rating
plate is the same as the power supply voltage in
your home. The service number is located on the
front edge of the oven cavity (visible when the
oven door is open).
Use a type H05RR-F power cord (minum length:
800 mm).
Warning: All the oven?s components operate at
230-240 V. When using a 400 V connection,
make sure that the voltage reaching the oven is
230-240 V, as illustrated in the side table.
Conductors X Electrical
numberconnection
H05 RR-F 3X4 mmq
1N+ ~
H05 RR-F 4X2.5 mmq
2N+ ~
H05 RR-F 4X2.5 mmq
3+ ~
H05 RR-F 5X1.5 mmq
3N+ ~
Interconnecting cooktop and oven
Before connecting the oven to the power supply,
check that the cooktop is among the ones listed in
the cooktop/oven pairing product sheet.
Connect the 3 pole and 4 pole connectors to the
respective connectors on the oven.
The 3 pole connectorsH) is lo (cated at the rear
right hand side of the control panel, the 4 pole
connector (J) is located at the top of the oven in the
left hand corner (see figure).
Connect the yellow/green striped earth wire ()
(K) from the cooktop to the screw located near the
3 pole connector.
WARNING: DO NOT CONNECT TO THE
POWER SUPPLY BEFORE YOU HAVE
FINISHED CONNECTING THE OVEN AND
THE COOKTOP.
Mount the oven in the kitchen unit.
Make sure the power cord is not entrapped.
54 |
ACEC
