Operation
Vent Control
ENERGY SAVER (HIGH, MED and LOW) -
ENERGY SAVER mode provides the most
energy efficient use of your room air condi-
QUIET ZONE
tioner. I nENERGY SAVER mode, the fan stops when the
EXHAUST CLOSED
compressor stops cooling. This feature can be used with
SMART COOL or cooling with any fan speed.
Open or close the vent by sliding the vent control lever to theAmana?s new air sampling system works to maintain set
appropriate setting.temperature within 1.5°F while in ENERGY SAVER mode.
Approximately every 5 minutes the fan will turn on and
?sample? the room air to determine if cooling is needed. If
EXHAUST - This setting opens the vent to move indoor airthe room is cool enough, the fan will cycle off. If the room
out.needs further cooling, the compressor will start along with
the fan until the set temperature is reached.
Note: To conserve energy, the unit should be set to the
ENERGY SAVER has a soft start fan feature. This feature
FAN ONLY mode when using this setting.
starts the fan in low speed to reduce noise.
CLOSED - In this position the vent is closed and room air
FAN ONLY - FAN ONLY circulates room air
is recirculated and filtered. This position should be used for
at the set fan speed without cooling. This
all normal cooling operations (see underlined cooling op-
feature can be turned off by pressing the FAN
tions on control panel).
ONLY, the SMART COOL, or the ENERGY SAVER button.
Indoor temperature is displayed in FAN ONLY mode.
Unit Control
SMARTLOWMEDHIGHENERGYFANDELAY
OFFCOOLFANFANFANSAVERONLYSET22TIMER
COOLICONGOLINGQUIET ZOQNEUIET ZONE
EXHAUST EX CLHAUSOSEDT CLOSED
Control Panel
OFF - Completely shuts off the unit.
SET Temperature - These key pads
increase or decrease the set tempera-
SMART COOL - SMART COOL adjusts the
ture.
fan speed of the unit to achieve the selected
temperature. The SMART COOL feature
uses computer logic to cool the room quickly
and quietly. The fan speed starts on high, automatically
DELAY TIMER - This button provides a
switches to medium, and finally goes to low as the room
temperature nears the set temperature.means of delaying the start up or shut down
of the air conditioner from 1 to 24 hours from the present
time. After setting the delay timer, the displayed time will
LOW FAN, MED FAN, HIGH FANcountdown to unit start or stop. See next page for details.
- These three buttons are used to
select either a low, medium or
high fan speed to cool. If FAN ONLY is selected these
buttons change fan speed without cooling. Selecting the
fan speed starts normal cooling.
3 |
ACEC
