WHIRLPOOL 3MAS4132FW2 Instruction Manual

$4.99

WHIRLPOOL 3MAS4132FW2 - It's a complete owner's manual ( also known as operating manual or user guide), and it's in PDF format. After placing order we'll send You download instructions on Your email address. See below for delivery information

The manual is available only in language(s): English

Link to manual will be sent on Your email address after You place order.

This product was added to our catalog on Tuesday 15 April, 2008.

Reviews

Write Review

Buy & Download

Product Reviews

There are currently no reviews for this product.

Other reviews

pascal grandjean - 11/02/2009

Excellent service. Service manuel conforme. C'est parfait. Merci!

Grace Towers - 05/22/2008

Very nice clear manual with specifications, exploded views and schematics, been searching for one of these for years. Thanks.

Jim Carrier - 08/02/2006

Outstanding and fast service! I received service manual in a moment after order. Thanks to this manual I can use my printer again!

Charles Dussier - 12/05/2006

Super vraiment excellent! la qualit� d'image est vraiment au rendez vous. fichier recuperrable dans la journ�e c'est impeccable! Fichier qui etait introuvable, je l'ai enfin ! merci !!:)

Francisco Dorfman - 06/13/2007

I was thinking I will never find this manual. User-Manuals had saved my Teac V-7010 which is full of specific functions. Superfast service, excellent document. Thank you very much!

Customers who bought this product also purchased

WHIRLPOOL 0027047 Service Manual	WHIRLPOOL 000 150 87 Owner's Manual	WHIRLPOOL 00027052 Service Manual
WHIRLPOOL 10C2MY Owner's Manual	WHIRLPOOL 10M12TA Owner's Manual	WHIRLPOOL 0027052 Owner's Manual

Click to see text excerpt from the manual

TROUBLESHOOTING
COMMONWASHINGPROBLEMS
Problem...Cause...Solution ...
Washer leaksFill hoses not tight.Tighten hoses. See Installation
YY
Instructions.
NOTE: After
checking these,YFill hose washers not properly seated.YReseat (reposition) washers. See
check householdInstallation Instructions.
plumbing.
YDrain hose clamp not properly YClamp drain hose.
installed or is off.
YDrain is clogged.YUnclog drain. Sink and standpipe
must be able to handle 64 L
(17 gallons) of water per minute.
YTub moved forward during unloading,YEnsure tub is centred before starting
causing water to deflect off of tub ring.washer.
YUnit not level, causing water to deflect YEnsure front feet are installed and
off of tub ring.nuts are tightened. Level washer.
YFill or spray rinses are deflecting ofYRedistribute the load, or reduce f
of load. Washer is overloaded or load load size.
is unbalanced.
Washer wonOt YDrain hose is clogged.YUnclog hose. See Installation
drain/spinInstructions for proper installation
of drain hose.
YLid is open.YClose the lid.
YEnd of drain hose more than 183 cm YLower drain hose.
(72 inches) above floor.
Too much detergent Ä� excessive sudsing.Use less detergent.
YY
YLow voltage or using an extension cord.YCheck electrical source or call
electrician. Do not use extension
cords.
Wet loadsYWrong cycle for load being washed.YChoose a cycle with a higher spin
speed.
YCold rinses.YCold rinses leave loads wetter than
warm rinses. This is normal.
Washer continues Y Top of drain hose is lower than waterYRaise the drain hose. It must be high-
to fill/drain or level in washer.er for proper operation.
cycle stuck
YDrain hose fits too tightly into YAdjust drain hose for loose yet secure
NOTE: Washerstandpipe.fit. See Installation Instructions.
pauses briefly
YDrain hose taped into standpipe.YDo not seal off drain hose with tape.
throughout eachThe hose needs an air gap.
cycle. This is normal.
Washer makesYLoad is unbalanced.YRedistribute load.
noiseYWasher is not level.YLevel washer. Reset rear leveling
legs. See Installation Instructions.
YNuts on front feet not tight.YTighten nuts.
Yellow shipping strap with cotter pins
YYSee Installation Instructions.
not completely removed.
12