care and cleaning
thoroughly in hot sudsy water and
WARNINGrinse completely before drying. Wire
whip should be hand washed and
Injury Hazarddried immediately. Do not wash wire
whip in a dishwasher.
noTe: Always be sure to unplug Unplug mixer before touching
beaters.
Stand Mixer before cleaning. Wipe
Failure to do so can result in Stand Mixer with a soft, damp cloth.
broken bones, cuts or bruises.Do not use household/commercial
cleaners. Do not immerse in water.
Bowl, flat beater and dough hook Wipe off beater shaft frequently,
may be washed in an automatic removing any residue that may
dishwasher. Or, clean them accumulate.
Beater To Bowl clearance
Your mixer is adjusted at the factory so that the flat beater just clears the
bottom of the bowl. If for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, clearance can be corrected as follows:
1. Turn speed control to OFF.
2. Unplug Stand Mixer or
disconnect power.
3. Unlock motor head.
4. Tilt motor head back and lock.
5. Remove bowl, beater, dough
hook, or wire whip if attached.
6. Turn screw (A) slightly
counterclockwise (left) to raise the A
flat beater, or clockwise (right) to
lower flat beater.
7. Attach flat beater and bowl.
8. Unlock motor head and lower.
9. Beater should just clear surface of
bowl. If it does not, repeat
steps 4-8.
noTe: If you over adjust the screw,
the bowl lock lever may not lock
into place.
noTe: When properly adjusted, the
flat beater will not strike on bottom
or side of bowl. If beater or wire whip
is adjusted too close so that it strikes
bottom of bowl, coating may wear
off beater or wires may wear through
on wire whip.
8 |
ACEC
