Location Requirements
AIR PURIFIER CARE
Cleaning
1
1
1. A 20 cm min. clearance
Do not block the air openings or place the air puriŢer on a soft
surface such as a bed or sofa. 2
Place air puriŢer on a �at, level surface at least 20 cm from
3
heat sources such as cookers or heaters.
4
This product is intended for indoor use only.
5
AIR PURIFIER USE1. Release tabs3. Bottom slot5. Front grille
2. HEPA Ţlter4. Pre-Ţlter
1.Turn the fan speed knob to Off.
Starting/Stopping Your Air PuriŢer2. Unplug air puriŢer or disconnect power.
NOTE: Before operating the air puriŢer, record the date of 3. Place Ţngers on the front release tabs. Gently push the tabs
installation on the HEPA Ţlter, which should be replaced annually in and pull the front grille forward to remove it.
under conditions of normal use and care. The pre-Å¢lter should be
4. Remove both Ţlters and set aside.
replaced every 3 months. To remove and replace either Ţlter, see
NOTE: DO NOT try to wash and reuse either the HEPA Ţlter
OFilter Replacement� in the OAir PuriŢer Care� section.
or the pre-Å¢lter.
5. Clean the air puriŢer with a soft, damp cloth.
6. Gently wash the front grille in soapy water.
ChangeNOTE: The grille is not dishwasher safe. Be sure all parts are
41HEPA Filter
completely dry before reassembling them.
Change7. Reassemble the Ţlters as shown in the previous illustration.
2Pre-Filter5
8. Place the bottom tabs on the front grille into the slots in the
3
Filterbase of the air puriŢer. Push the top of the grille forward until
Reset6
the grille locks into place.
9. Plug in air puriŢer or reconnect power.
1. Low fan speed3. High fan speed5. Pre-Å¢lter indicator
10. Turn the fan speed knob to the desired fan speed.
2. Medium fan 4. HEPA Ţlter light
speedindicator light6. Filter Reset button
1.Plug into a grounded (earthed) outlet.
NOTE: Both Ţlter indicator lights will �ash once during a self-
test when the air puriŢer is turned on or after a power cut.
2.Turn the fan speed knob to the large fan icon (High), the
middle fan icon (Medium) or the small fan icon (Low) to select
the desired fan speed.
3.Turn the fan speed knob to Off to turn off the air puriŢer.
3 |