Start Your Air Conditioner?Digital Control
Power Saver?Fan runs only when cooling is needed. You
can select the fan speed by pressing FAN SPEED.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
Fan Speed
NOTES:
NOTE: The Fan Speed button will operate only when Cool, Fan
When the air conditioner is off, the Room indicator light is lit Only or Power Saver mode has been selected.
and the display shows the current room temperature.
1. Press FAN SPEED until you see the indicator light come on
If the room temperature is below 55oF (13oC), the display will for the setting you desire.
show 55oF (13oC). If the room temperature is above 99oF 2. Choose Turbo, High or Low.
(37oC), the display will show 99oF (37oC).
When the Set indicator light is lit, the display shows the
temperature control setting. See ?Temperature.?
When the Hour indicator light is lit, the display shows the time
remaining on the Timer setting. See ?Timer Delay.?
1. Remove clear protective film from control panel and front
Filter Monitor
panel badge.
2. Press POWER to turn on air conditioner.
1. When Filter indicator light is lit or flashing, remove, clean and
replace air filter. See ?Cleaning the Air Filter.?
2. Press and hold FILTER for 3 seconds after cleaning and
replacing the air filter. This resets the Filter Monitor.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous
settings for 3 seconds, and then display the room
temperature.
3. Select mode. See ?Mode.?NOTE: After 360 hours of fan operating time, the Filter indicator
light will turn on. It will remain on for 180 hours or until you press
4. Select fan speed. See ?Fan Speed.?FILTER. After 180 hours, it will flash. It will continue flashing until
5. Set temperature. See ?Temperature.?you press FILTER.
ModeTemperature
1. Press MODE until you see the indicator light come on for the
Press the plus button to raise the temperature. Room
setting you desire. indicator light will turn off, and Set indicator light will turn on.
2. Choose Auto, Cool, Fan Only or Power Saver.Display shows the Temperature control setting. Each time you
Auto?Cools room while it automatically controls fan press or hold the plus button, the temperature will increase
1o until it reaches 86°F (30°C).
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.NOTE: After 3 seconds, Set indicator light will turn off, and
Cool?Cools room. You can adjust temperature by Room indicator light will turn on. Display will show the current
pressing the plus or minus button. You can select fan room temperature.
speed by pressing FAN SPEED.
Fan Only?Only the fan runs. You can select the fan
speed by pressing FAN SPEED, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
15 |
ACEC
