th
 When the set point is increased, a line appears above the 6
?
Sense System control temperature line. When the set point Fan Speed (in Cooling or Fan Only modes)
th?
is decreased, a line appears below the 6 Sense System
control temperature line.1. Press FAN until you see the symbol glow for the desired
setting.
AB
C
High
2. Choose Auto, High or Low.
 Auto?automatically controls fan speed depending on
current room temperature and temperature control
Low
Dsetting.
NOTE: Auto fan speed cannot be selected in Fan Only
mode.
A.6th Sense? System control C.6th Sense? System control
symboltemperature line
B.Dry mode symbolD.Auto fan speed symbol
 High?for maximum cooling
 If the current room temperature is lower than the temperature
set point, Dry mode is selected. Fan runs on Auto speed only.
 If the current room temperature is higher than the
temperature set point, Cooling mode is selected. Fan speed
may be selected by the user.
 Low?for minimum cooling
th?
1. Press 6 Sense.
Temperature
2. In Cooling mode, press FAN to select Auto, High and Low. Press the up arrow button to raise the temperature. Press the
up arrow button once to increase the set temperature by 2oF
?(1oC), or press twice to increase the set temperature by 4oF
RapidCool Control
(2oC).
Used for fast cooling. The air conditioner automatically sets the
fan speed to High and the temperature to 64°F (18oC).
th?
NOTE: 6 Sense System control button does not operate when
?
RapidCool control is selected.
?
1. Press RapidCool. The air conditioner automatically sets the
 Press the down arrow button to lower the temperature. Press
fan speed to High and the temperature to 64°F (18oC).
the down arrow button to decrease the set temperature by
2oF (1oC), or press twice to decrease the set temperature by
4oF (2oC).
?
2. To turn off RapidCool control, press RapidCool control,
Mode, Fan, Power or the up arrow button.NOTES:
 In the Cooling mode, the temperature can be set between
64oF and 90oF (18oC and 32oC).
th?
 In Fan Only mode and 6 Sense System control, the
temperature cannot be set.
 To change the temperature display from oF to oC, press the
change display button on the remote control.
12 |