To operate air conditioner with remote control
To select the mode:Press the AutoCool,
NOTE: Two AA batteries (notAutoCool
Cool, Fan Only, or Power Saver button.
POWER
ON/OFFincluded) power the remote
When air conditioner is operating in
Cool
control. Replace batteries after
AutoCool mode, fan speed is adjusted
AutoCool
six months of use, or when theFan Only
automatically. When air conditioner is
remote control starts to lose
CoolTurbooperating in Fan Only mode, fan speed is
power. Be sure to installPower Saver
automatically set at Turbo. When air
Fan OnlyHighbatteries with correct polarity.
FANconditioner is operating in Cool or Power
SPEED
Power SaverLowSaver mode, you can adjust the fan speed.
Turbo
To select the fan speed (in Cool or
High
Power Saver mode only):Press theFANSPEED
Turbo, High or Low button.Low
Temp / Time
Timer
To set Timer for a 1 to 24 hour delay
Timer
until air conditioner turns on (air
conditioner must be in OFF mode):
1. Press the Timer button.
To turn the air conditioner on or off:ON/OFFPOWER2. Press thesbutton to change delay time
Press the POWER ON/OFF button. (1 to 24 hours).
3. Press the Timer button again or wait 10 seconds.
To raise the temperature:Press
thes button. Each time you press or holdTo set Timer for a 1 to 24 hour delay until air
thes button, the temperature will go upconditioner turns off (air conditioner must be
Temp / Time
1! until it reaches 86!F (30!C). in ON mode):
To lower the temperature:Press1. Press the Timer button.
thet button. Each time you press or hold2. Press thes button to change delay time
thet button, the temperature will drop 1! until it(1 to 24 hours).
reaches 64!F (18!C).
3. Press the Timer button again or wait 10 seconds.
NOTE: In the event of a power failure, your air
conditioner will operate at the previous settings when
the power is restored.
6 |
ACEC
