User Maintenance (cont'd)
Removing and replacing the outer dishwasher door
DIshwasher door needs to be removed during custom installation of specialty panels. This procedure is to
add custom panels only, and should not be considered a part of routine user maintenance. To order custom
panels, call Amana Customer Service at (800) 843-0304.
To remove:
1. Unlatch and open door. Using a Phillips head screwdriver,
remove two (2) screws from inner door. Save screws to
reassemble door.
2. Close and latch door while holding both sides.
3. Place one hand on each side of door and pull down at
1
top approximately /4". Pull entire door assembly toward
you to remove.
4. Place door where it will not get scratched or damaged while
completing installation or other maintenance.
metal
To replace:liner
1. Fit the slots on each side of top door edge over
the tabs on the metal liner. Push on sides to
insure the door is flat. Push up from bottom until
there is no gap between door and console.
door
2. Unlatch door and open while supporting outer
door on both sides and at bottom to keep in
place. Align screw holes and replace screws.
side view
Adjusting Spring Tension
A correct spring setting allows the dishwasher door to remain horizontal in an
opened position, but should close easily with a slight push upwards.
To adjust spring tension:
?To increase tension, move spring to a hole near the rear of the
dishwasher.
?To decrease tension, move spring to a hole near the front of the
dishwasher.
12 |
ACEC
