Installation
To Install:
1. Install hinge assemblies:
1. Pull both rails out to full
5
Y Install top hinge loosely with �16� hex head
extension.
screws.
Y Install center hinge with Phillips
screws.
2. Place hinge side of refrigerator door
2. While supporting door front,
hook supports into tabson center hinge pin.
located on inside of rail.
3. While holding refrigerator door
upright, tighten down top hinge
5
with �16� hex head driver.
4. Reconnect two-pin connector.
3. Lower door front into
5. Replace top hinge covers.
final position.
Handles
Note: If not installed, the handle is located in the
interior of the fresh food section or attached to the
back of your refrigerator.
4. Place the basket cradles back onto the side rails.
Remove and discard handle packaging and tape.
Align snaps with the slots on the side rails and
Plastic Handle
press each snap toward the rail until it clicks.
To Install:
5. With rails pulled out to full extension, set the
1. The handles are to be oriented
basket straight down into the basket cradles.
as shown.
Basket cradle
2. Align door handle clip with the
snap attachments
door studs.
3. Ensure the large hole in the
mounting clip is positioned
downon both ends of the
6. Slide upper basket into freezer. Make sure that rearhandle.
of basket hooks behind rail catch.
Door
Stud
4. Rotate the handle so that the
handle is flat against the door.
Door Reinstallation
Materials Needed:
Y Phillips screwdriver
5
Y�16� hex head driver
5 |
ACEC
