Care & Cleaning
Self-Clean OvenTo set Self-Clean:
CAUTIONNote: Oven temperature must be below 400° F to program
a clean cycle.
Y It is normal for parts of the range to become hot during a
self-clean cycle.1. Close the oven door.
Y To prevent damage to oven door, do not attempt to open2. Move door lock lever right to the locked position.
the door when LOCK is displayed.
Y Avoid touching cooktop, door, window or oven vent area
during a clean cycle.
Y Do not use commercial oven cleaners on the oven finish
or around any part of the oven. They will damage the3. Press the Clean pad.
finish or parts.Y CLEAN flashes in the display.
4. Press the 2 or 1 pad.
The self-clean cycle uses above-normal cooking temperaturesY OMEd� (Medium soil, 3 hours) is displayed
to automatically clean the oven interior.
The oven should be cleaned regularly by wiping up spilloversIf the door is not closed, beeps will sound
to prevent excessive smoke and flare-ups. Do not allow aand Odoor� will display. If the door is not
heavy build-up of soil to accumulate in the oven.closed within 45 seconds, the self-cleaning operation will
be canceled and the display will return to the time of day.
During the cleaning process, the kitchen should be well5. Press the 2 or 1 pad to scroll through the
ventilated to get rid of normal odors associated with cleaning.
self-cleaning settings.
OHVy� (Heavy Soil, 4 hours)
Before Self-Cleaning
1. Turn off the oven light before cleaning. The light may burnOMEd� (Medium soil, 3 hours)
out during the clean cycle.OLITE� (Light Soil, 2 hours)
2. Remove all pans and oven racks from the oven. The ovenChoosing the soil level of the oven automatically programs
racks will discolor and may not slide easily after a self-the self-cleaning time.
clean cycle if they are not removed.6. After four seconds, the oven will start cleaning.
3. Clean oven frame, door frame, area
outside of gasket, and around theY The cleaning time will start counting down in the display.
opening in the door gasket with aY LOCK will appear in the display.
nonabrasive cleaner such as BonY CLEAN will appear in the display.
Ami* or detergent and water. The
self-cleaning process does notTo Delay a Self-Clean Cycle:
clean these areas. They should be1. Press the Clean and Timer pads.
cleaned to prevent soil from baking on during the cleanY DELAY and 00:00 will appear in
cycle. (The gasket is the seal around the oven door andthe display.
window.)
2. Press the 2 or 1 pad to set the amount
4. To prevent damage, do not clean or rub the gasket aroundof time you want to delay the cycle. The
the oven door. The gasket is designed to seal in heatdelay time can be set from ten minutes
during the clean cycle.(00:10) to 11 hours, 59 minutes (11:59).
5. Wipe up excess grease or spillovers from the oven bottom.
This prevents excessive smoking, flare-ups or flaming3. Press the Clean pad.
during the clean cycle.Y CLEAN will flash.
6. Wipe up sugary and acidic spillovers such as sweet4. Press the 2 or 1 pad.
potatoes, tomato, or milk-based sauces. Porcelain enamelY OMEd� (Medium soil, 3 hours) is displayed.
is acid-resistant, not acid-proof. The porcelain finish maycont.
discolor if acidic spills are not wiped up before a self-clean
cycle.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
15 |