Maintenance
Oven DoorLeveling Legs
CAUTIONCAUTION
Y Do not place excessive weight on or stand on an open
Be sure the anti-tip bracket secures one of the rear
oven door. This could cause the range to tip over, break
leveling legs to the floor. This bracket prevents the range
the door, or injure the user.
from accidentally tipping.
Y Do not attempt to open or close door or operate oven until
door is properly replaced.
Be sure the range is leveled when installed. If
Y Never place fingers between hinge and front oven frame.the range is not level, turn the leveling legs,
Hinge arms are spring mounted. If accidentally hit, thelocated at each corner of the range, until
hinge will slam shut against oven frame and could injure
range is level.
your fingers.
ANTI-TIP BRACKEANTI-TIP BRACKETT
To remove:
1. When cool, open the oven door toLEVELING LEGLEVELING LEG
the first stop position (opened
about four inches).Oven Light (style varies by model)
2. Grasp door at each side. Do not
use the door handle to lift door.
CAUTION
3. Lift up evenly until door clears
hinge arms.Y Disconnect power to range before replacing light bulb.
To replace:Y Allow oven to cool before replacing light bulb.
1. Grasp door at each side.Y Make sure bulb cover and bulb are cool before touching.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door isTo replace oven light bulb:
completely seated on the hinges. Push down on the topBULB COVER
1. When oven is cool, hold bulb cover
corners of the door to completely seat door on hinges.
in place, then slide wire re-
Door should not appear crooked.
tainer off cover. Note: Bulb
cover will fall if not held in
Note: The oven door on a new range may feel Ospongy�
place while removing wire
when it is closed. This is normal and will decrease with use.
retainer.WIRE
RETAINER
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance bulb.
Oven Window
4. Replace bulb cover and secure with wire retainer.
To protect the oven door window:5. Reconnect power to range. Reset clock.
1. Do not use abrasive cleaning agents such as steel woolOR
scouring pads or powdered cleansers as they may scratch
1. Use a dry potholder and very carefully unscrew bulb cover
the glass.
and bulb.
2. Do not hit the glass with pots, pans, furniture, toys, or other
2. Replace with a 40 watt, oven-rated appliance bulb. Bulb
objects.with a brass base is recommended to prevent fusing of
bulb into socket.
3. Do not close the oven door until the oven racks are in
place.3. Replace bulb cover and reconnect power to range.
Scratching, hitting, jarring or stressing the glass may weaken4. Reset clock.
its structure causing an increased risk of breakage at a later
date.
19 |
ACEC
