3gb53231b.fm5 Page 18 Friday, April 11, 2003 12:21 PM
INSTALLATION
Electrical connection
? The electrical connections must comply with local regulations.
? The data relevant to the voltage and power absorption are L
indicated on the rating plate.
? The earthing of this appliance is compulsory by law.Earth
? The manufacturer cannot be held responsible for any (Yellow/Green)
injury to persons or animals or damage to property arising
N
from failure to comply with these requirements.
? When the cooktop is installed, provide a single-pole
circuit breaker with a contact separation of at least 3 mm.
? If necessary, the electrical power cable must be replaced
exclusively with a power cable having identical
characteristics to the original supplied by the
manufacturer (type H05V2V2-F - T90°C or type HO5RR-
F). This operation must be performed by the After Sales
Service or a qualified electrician.
Connection to gas supply
The gas supply system must comply with local regulations.
You can find specific local regulations for some countries, in
the separate National Safety Regulations Sheet supplied.
If no information concerning your Country is given, please ask
details to your Installer.
The connection of the cooktop to the gas pipe network or gas
cylinder must be made by means of a rigid copper or steel pipe
with fittings complying with local regulations, or by means of
a continuous-surface stainless steel hose complying with local
regulations. Interpose gasket (B) in the elbow connection.
The maximum length of the hose is 2 m.
FOR BELGIUM ONLY: It is necessary to replace the elbow
connection (A) on the appliance, with the one supplied.
Important: if a stainless steel hose is used, it must be
installed so as not to touch any mobile part of the furniture.
It must pass through an area where there are no
obstructions and where it is possible to inspect it on all its
length.
After connection to the gas supply, check for leaks with
soapy water.
Attention: Should you experience difficulty in turning the
burners knobs, please contact the After Sales Service for the
replacement of the burner tap.
18 |
ACEC
