Minimum Requirement for Cooktops Placed Side byElectrical Installation Requirements
SideInstallation of this product must conform with local codes
? 2 inches must separate cutout of each cooktop.or in the absences of local codes with the current
? 1 inch must separate side flanges of each cooktop.National Electric Code ANSI NFPA 70.
Minimum Cabinet RequirementsCooktop requires a 3 wire 240 volt, 60 hertz, AC circuit
? Single cabinet installation requires a 24 inch width baseprotected by a separate 15 amp circuit breaker or time
cabinet.delay fuse. Ground cooktop using #10 gauge ground
wire attached to burner box.
Minimum Clearances to Combustible Material
Junction Box Location
Junction box must be located within 30 inches of power
supply entry point.
Power Supply Connection
A
WARNING
BTo avoid risk of electrical shock, personal injury, or
C
Hdeath, make sure your cooktop has been properly
grounded and always disconnect it from main power
supply before any servicing.
G
To avoid risk of electrical shock or personal injury when
connecting copper leads to aluminum house wiring, use
D
only connectors designed for joining copper to
Ealuminum. Follow connector manufacturer?s
recommendations closely.
F
To avoid risk of electrical shock or personal injury, do
not ground through neutral wire if installed in mobile
home or if local codes do not permit grounding through
neutral wire
Cooktop has approximately 36 inches of flexible wire
conduit attached to rear of cooktop. Approximately 4
inches of bare ground wire and 2 insulated wires, brown
A?21 inches
and red, extend beyond end of conduit. Connect wire
B?Minimum of 30 inches between top of cooking
leads extending from conduit to house wires inside
surface and bottom of an unprotected wood or
junction box (Junction box not included). Refer to local
metal cabinet. Minimum of 24 inches between
codes and attach according to examples below.
cooking surface and protected wood or metal
cabinet above range. Cabinet bottom must be
3 Wire Connection (Cooktop Wire?House Wire)
protected by at least 1 inch thick millboard with
Bare?Ground (Green)
not less than No. 28 MSG sheet steel, .015 inch
Red?Power Line (Red)
thick stainless steel, .024 inch thick aluminum, or
Brown?Power Line (Black)
.020 inch thick.
C?13 inches minimum
4 Wire Connection (Cooktop Wire?House Wire)
D?0 inches
Bare?Ground (Green) and Neutral (White)
E?3 inches minimum
Red?Power Line (Red)
F?24 inches minimum
Brown?Power Line (Black)
G?0 inches
H?18 inches minimum
Figure 3
5 |
ACEC
