3gb05179.fm5 Page 2 Monday, April 2, 2001 5:56 PM
CONSUMPTION DATA?Spin Speed Reduction? buttonNOTES AND INDICATIONS FOR USE
Reduces the predetermined automatic
LoadWaterEnergyApprox.maximum spin speed.WATER LEVEL
ProgrammeIt may not be visible as the cycle is optimised
ProgrammeDurationIn some programmes the maximum final spin for a minimum water consumption without
(kg)(l)(kWh)(hours:minutes)speed is limited to go easy on your laundry compromising washing results.
Cotton 95°5.5512.002:15items. Selection of a higher spin speed is not
possible.SPIN SPEED CONTROL
Cotton 60°5.5471.042:25Spin speed may be reduced automatically or
Cotton 40°5.5470.652:15PROGRAMME CHANGEmay even be excluded in the case of small
Synthetics 60°2.5550.801:25loads with highly absorbent garments (e.g.
To reselect a programme when a cycle has already
Synthetics 40°2.5500.600:50bathrobes, bathmat).
begun:This control avoids cloth and machine
Delicates 40°1.5500.500:45
1. Switch off the appliance by pressing thedamage and excessive vibrations and
Wool 40°1.0500.500:40?ON/OFF? button.consequent noise produced by the machine
Silk 40°1.0370.400:40
2. Select the new programme.due to load unbalance: by selecting high spin
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized 3. Start the programme by pressing the ?ON/OFF? speeds the noise level increases.
conditions in compliance with Standard IEC 60 456.
Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and button.MOTOR NOISE
temperature, the load and the type of wash.The running noises of the new, electronically-
PROGRAMME ENDcontrolled motor are not the same as the
ADD DETERGENTS, CLOSE THE DOOR AND SELECT SELECT ANY DESIDERED OPTIONones you are used to from your old appliance.
THE PROGRAMME1. At the end of the programme the programme
?Rapid Wash? buttonDon?t be surprised - modern technology has a
Add the detergent as described in the programme For quick, economical washes. selector moves to the stop position. modern sound.
2. To unload the machine wait for the door to
table or in the chapter ?Detergents and Additives? in Ideal for minimum loads of lightly-soiled articles.CLEANING THE FILTER
the booklet.unlock (about 1 minute).
Note: reduce the detergents quantity.3. Switch off the appliance, open the door and To ensure an impeccable function of the
1. Open the tap.pump, check the filter regular and clean it if
?Rinse Hold? buttontake out the laundry.
2. Set the programme selector to the desired The laundry remains in the last rinse water 4. Close the tap and leave the door ajar to allow necessary.
programme.
without progressing to the final spin cycle to the drum to dry out.
3. Special options can be selected.avoid creasing and prevent colours from
4. Check that the door is well closed and turn on the changing.
washing machine by pressing the ?ON/OFF? This option is particularly recommended for the
button. The indicator lights up, indicating that programme ?Synthetics? or ?Delicates?.
the washing machine is on. This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Terminate the ?Rinse Hold? option:
Press the ?Rinse Hold? button again; the
programme will terminate automatically with the
final spin cycle for the present wash programme.
If you do not wish to spin the clothes, turn the
programme selector knob to the ?Drain? programme.
?Cold Wash? button
With this option water is heated only up to 20°C.
Whirlpool is a registered trademark of Whirlpool USA.
5019 301 05179
Black Process Plate |
ACEC
