a. Water inlet fault (no or insufficient water supply)c. Electrical module fault
The ?Water tap? indicator is on or the display The display shows ?F4? to ?F15?.
alternately shows ?FH?. Switch off the appliance Switch off the appliance. Select a programme
by turning the programme selector to the ?? and press the ?Start/Pause? button once
position and unplug it.again. The programme will continue.
Check whether:If the fault re-occurs, contact After Sales
the water tap is completely open, and the water Service (See ?After-Sales Service?).
supply pressure is sufficient;d.Water Stop fault (if available)
the water inlet hose is kinked;An audible tone sounds. The light of the Water
the mesh filters are clogged (see ?Care and Stop indication is on. The display shows ?FA?
Maintenance? / ?Water Hose Mesh Filters?);and the pump is running. Switch off the
the water inlet hose is frozen.appliance by turning the programme selector to
Connect the appliance to the electrical supply.the ?? position, unplug the appliance and
Reselect the desired programme and press the make sure that the water tap is closed.
?Start/Pause? button again to continue with The ?Water Stop? may have been triggered by:
the programme (do not add detergent for this 1.too much foam.
programme)2.a leak in the inlet hose or in the appliance.
b.Draining out faultTilt the appliance forwards carefully to allow
The display alternately shows ?FP?. Switch off the collected water to flow out.
the appliance by turning the programme Then:
selector to the ?? position and unplug it.1.connect the appliance to the electrical supply,
Check whether:2.open water supply to machine (if ?Start/Pause?
the drain hose is kinked (see ?Installation button is not pressed, but machine begins to fill,
Instructions?);close water supply and call After-Sales Service),
the pump / filter are blocked (see ?Removing the 3.reselect the desired programme and press the
Filter / Draining Residual Water?).?Start/Pause? button (there is no need to add
IMPORTANT: before draining, allow the wash additional detergent). The programme will continue.
water to cool down.If the faults occurs again, call After-Sales
the drain hose is frozen.Service with details about the fault (see ?After-
Connect the appliance to the electrical supply.Sales Service?).
Reselect the desired programme and press the
?Start/Pause? button again to continue with
the programme (do not add detergent for this
programme). If the fault re-occurs, contact
After-Sales Service (see ?After-Sales Service?).
AFTER-SALES SERVICE
Before contacting After-Sales Service:Specify:
1.Try to remedy the problem yourself (see The nature of the problem.
?Troubleshooting guide?). The exact model of the appliance.
2.Restart the programme to check whether the The service code (number after the word SERVICE).
problem has solved itself.
3.If the machine continues to function incorrectly,
call After-Sales Service.
The After-Sales Service sticker is on the
inside of the door.
Your full address.
Your telephone number and area code. After-Sales
Service phone numbers and addresses are given on
the guarantee card. Alternatively, consult the dealer
where you purchased the appliance. |
ACEC
