30105536aGB.fm Page 18 Thursday, December 30, 2004 10:53 AM
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and inspection5.Drain
? After unpacking, make sure that the washing ? Connect the drain hose to the siphon or hook it
machine is undamaged. If in doubt, do not use the over the edge of a sink by means of the ?U? bend
washing machine. Contact After-Sales Service or supplied
your local retailer? If the washing machine is connected to an
? Check that the accessories and supplied parts are integrated drainage system, ensure the latter is
all presentequipped with a vent to avoid simultaneous
? Keep the packaging materials (plastic bags, loading and draining of water (siphoning effect)
polystyrene parts, etc.) out of reach of children, 6.Electrical connection
as they are potentially dangerous? Electrical connections must be carried out by a
qualified technician in compliance with the
2.Remove the transport boltsmanufacturer's instructions and current standard
? The washing machine is fitted with transport safety regulations
bolts to avoid any possible damage to the interior ? Data regarding voltage, power consumption and
during transport. Before using the machine, it is
protection requirements is given on the inside of
imperative that the transport bolts are removedthe door.
? The appliance must be connected to the mains by
3.Install the washing machinemeans of a socket with an earth connection in
? Remove the protective film from the control
accordance with current regulations. The
panelwashing machine must be earthed by law. The
? Move the appliance without lifting it by the manufacturer declines all liability for damage to
worktopproperty or injury to persons or animals due to
? Install the appliance on a solid and level floor non-compliance with the directions given above
surface, preferably in a corner of the room? Do not use extension leads or multiple sockets
? Make sure that all four feet are stable and resting ? Before any maintenance on the washing machine
on the floor and then check that the washing disconnect it from the mains supply
machine is perfectly level (use a spirit level).? After installation, access to the mains plug or to
4.Water inletdisconnection from mains supply must be
? Connect the water supply inlet hose in ensured at all times via a double-pole switch
accordance with the regulations of your local ? Do not operate the washing machine if it has
water companybeen damaged during transport. Inform the
? Water inlet: Cold water onlyAfter-Sales Service
? Water tap:3/4? threaded hose ? Mains cable replacement is only to be carried out
connectorby After-Sales Service
? Water pressure ? The appliance must only be used in the
(flow pressure):100-1000 kPa (1-10 bar).household for the prescribed uses
Minimum housing dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
18
Black process 45.0° 100.0 LPI |
ACEC
