30105539aGB.fm Page 15 Friday, January 21, 2005 11:43 AM
b.Draining faultd.Water Stop fault (if available)
Waste water not pumped out. The ?Water Stop? may have been triggered by:
In models with LCD display, the display shows:1. excess foaming
2. a leak in the washing machine
In this case the pump is switched on automatically
in order to drain the water
For models with a fault display, depending on the
model, ?FP? lights up and remains lit or flashes. If a In models with LCD display, the display shows:
?Clean pump? indication is fitted, the red indication ?
next to it lights up.Water Stop Fault?
For models with no fault display, the washing For models with a fault display, the ?Water Stop?
machine stops in the appropriate programme step.indicator light lights up. The display shows ?FA? or
alternately ?F? and ?A? and the pump is running.
Stop the appliance and unplug it.
Check whether:Switch off the appliance, unplug it and make sure
kinks are present in the drain hose;that the water tap is closed.
Carefully tilt the appliance forwards to allow the
the pump or the filter is blocked (see ?Removing water to flow out.
the filter?)
IMPORTANT: make sure the water has cooled Then:
1. Plug in the appliance.
before draining the appliance.
the drain hose is frozen up2. Turn the water tap on (if water immediately
Plug in the appliance once again.flows into the appliance again, without the
appliance running, there is a fault. Shut the water
Select and start the ?Drain/Reset? programme.tap, then call After-Sales Service).
If the fault occurs again, please contact After Sales
Service (see ?After Sales Service?).3. Select and start the desired programme again.
c. Fault in an electrical component
The appliance stops during the programme.
If a digital or LCD display is fitted, ?F4? to ?F31? are
also displayed.
Select and start the ?Drain? or ?Reset? programme.
Next, select and start the desired programme.
For models with no fault display, the washing
machine stops in the appropriate programme step.
Switch the washing machine off and back on again
to continue the programme.
If the fault persists, please contact After Sales
Service (see ?After Sales Service?).
15
Black process 45.0° 100.0 LPI |
ACEC
