TROUBLESHOOTING GUIDE
Detergent and additive product residues
This appliance is equipped with safety functions
which detect faults at an early stage anin dispenser at end of wash.d react
appropriately.Check whether:
the siphon is correctly installed and clean
Often, however, the faults detected are small
enough to be solved in a matter of minutes.(see ?Maintenance and Cleaning?/
?Dispenser Cleaning Instructions?);
The appliance will not start, no lamp enough water is being supplied. The mesh
lights up.filters could be clogge?Maind (see tenance
Check whether:and Cleaning?/?Water Hose Mesh Filte?).rs
the appliance is plugged in;The appliance vibrates during the spin
the wall socket is functioning correccycle.tly (use a
table lamp or similar).Check whether:
The appliance will not start, but the pilot the appliance is level and solidly installed on
light is on.all feet (s?Installationee instruc?); tions
Check whether: the transport screws and transport bar have
been removed. Before starting up the
the appliance lid is properly closed;
a programme has been selected;appliance, the transport screws and the
the programme is started;transport bracket must be removed
the water tap is open.(see ?Installation instructions?).
The appliance stops during the Final spin results are poor.
programme. the appliance has an imbalance detection and
Check whether:correction system (depending on model).
If individual heavy articles are loaded (bathmat,
the ?Rinse Hold? button is pressed: terminate
this option;bathrobe, etc.) this system may reduce the spin
speed automatically to protect the appliance. It
the water tap is open;may even interrupt the spin cycle altogether, if
the pump / foreign body trap are blocked (see
the imbalance is too great after several spin
?Removing the Foreign Body? Tra); pstarts;
Insufficient or no water supply. if the laundry is too humid at the end of the
Check whether:cycle, add more articles of laundry to balance
the load and repeat the spin cycle;
the water tap is completely open, and the
water supply pressure is sufficient; excessive foam formation may prevent
the water inlet hose is kinked;spinning. Use less detergent.
the mesh filters are clogged (see Check whether:
?Maintenance and Cleaning?/?Water Hose the pump impeller is obstructed (see
?Removing the Foreign Body Trap?);
Mesh Filters?);
the water inlet hose is frozen. the lid was opened during the delicate or
wool programme. Close the lid and select a
Reselect the desired programme and start again spin programme.
to continue with the programme (do not add
detergent for this programme).
The appliance does not drain out the
water.
Check whether:
drain hose is kinked (see ?Installation
Instructions?);
the pump/ foreign body trap are blocked (see
?Removing the Foreign Body? Tra); p
IMPORTANT: Before draining, allow the wash
water to cool down.
the drain hose is frozen.
Reselect the desired programme and start again
to continue with the programme (do not add
detergent for this programme).
If the fault re-occurs, contact After-Sales Service
(see ?After-Sales Service?).
the ?Rinse Hold? button is pressed: terminate
this option.
28 |
ACEC
