Press the minus TEMP button to lower the temperature. The
Set indicator light will turn on. Each time you press or hold To operate air conditioner with remote control
the minus TEMP button, the temperature will go down 1o until
it reaches 64°F (18°C).
NOTE: After 3 seconds, the Set indicator light will turn off and
the display will show the current room temperature.
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Indicator light will flash.
COOLFANFAN
SPEED
2. Press the plus or minus TEMP button to change the delay AUTO
Power saver
time from 1 to 24 hours.TIMER
3. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To set the Timer to turn on the air conditioner, keeping
previous settings:
POWER
1. Turn off air conditioner.
2. Press TIMER. Indicator light will flash.
3. Press the plus or minus TEMP button to change delay time
(1 to 24 hours).NOTE: Two AAA batteries (included) power the remote control.
Replace batteries after 6 months of use, or when the remote
4. Press TIMER again or wait 10 seconds. Indicator light will
remain on.control starts to lose power.
To turn the air conditioner on or off:
To set the Timer to turn on the air conditioner, changing
the previous settings:Press POWER.
1. Turn air conditioner on.
POWER
2. Adjust Mode to Cool, Fan Only, or Power Saver.
3. Adjust Fan Speed to Turbo, High or Low, or Auto.
To select the mode:
4. Adjust temperature between 64°F (18oC) and 86°F (30oC).
Press COOL, FAN, or POWER SAVER.
5. Turn off air conditioner.
6. Press TIMER. Indicator light will flash.FAN
7. Press the plus or minus TEMP button to change delay time
COOL
(1 to 24 hours).
8. Press TIMER again or wait 10 seconds. Indicator light will
Power saver
remain on.
To clear Timer delay program:To select the fan speed:
NOTE: Air conditioner can be either on or off.Press FAN SPEED for Turbo, High or Low or AUTO.
Press and hold TIMER for 3 seconds. Indicator light will turn off. NOTE: Auto fan speed cannot be selected in Fan Only mode.
To see the remaining time (in hours):FAN
1. Press TIMER once after it has been programmed. SPEED
2. While the display is showing the remaining time, you can AUTO
press the plus or minus TEMP button to increase or decrease
the time.
9 |