RINSE ONLY
Option Selections
Use this cycle for rinsing dishes, glasses, and silverware that will
not be washed right away. You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
anytime before drying begins.
Do not use detergent with this cycle.
No Heat Dry
Select this option to dry dishes without heat and save energy. WashRinseRinseMainRinseFinal DryTimeWater
WashRinse(min)UsageThe dishes take longer to dry, and some spotting can occur.
(gal/L)
202.9/10.9
Canceling a Cycle
You can cancel a cycle at any time.For best drying, use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
1. Turn the cycle control knob slowly clockwise until you hear
NOTE: No Heat Dry is an option with all cycles except Rinse
water draining. Let the dishwasher drain completely.
Only.
2. Open the door.
3. Turn the cycle control knob to Off.Heated Dry
Select this option to dry dishes with heated air. For best drying
Changing a Cycle or Setting
results, use a liquid rinse aid and heated drying.
You can change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the cycle control knob clockwise.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE: Turning the cycle control knob can cause the covered
detergent dispenser section to open and release the
NOTE: Heated Dry is an option with all cycles except Rinse Only.
detergent. Check the covered section if the cycle uses
detergent in both sections.
4. Close the door firmly until it latches. The dishwasher starts a Plate Warmer
new cycle.
Use the Plate Warmer cycle to warm serving dishes or dinner
plates.
Adding Items During a CycleNOTE: Use the Heated Dry option.
You can add an item anytime before the main wash starts, or the 1. Close and latch the door.
cycle control knob reaches Normal Wash. 2. Turn the cycle control knob to Plate Warmer.
1. Lift up the door latch to stop the cycle. Wait for the spraying 3. Allow 8 minutes for the cycle to heat the dishware.
action to stop before opening the door.
4. Turn the cycle control knob to Off.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
11 |
ACEC
