Canceling a CycleOption Selections
Anytime during a cycle, press CANCEL/DRAIN. Your dishwasher You can customize your cycles by pressing an option. If you
starts a 2-minute drain, if needed, and clears all indicators.change your mind, press the option again to turn off the option,
NOTE: If your dishwasher does not need draining, the or select a different option if desired.
dishwasher stops and clears all indicators.You can change an option anytime before the selected option
begins. For example, you can turn off the drying option anytime
To stop the drainbefore drying begins.
After a wash cycle, the dishwasher remembers the options used.
You can press CANCEL/DRAIN again to stop the drain It uses the same options in the next wash cycle, if you press only
immediately. Be sure to drain the dishwasher before starting a START/RESUME.
new cycle.
Soak & Scour (on some models)
To clear the indicators
Select this option to presoak your dishes for 4 hours in your
Press CANCEL/DRAIN before starting the dishwasher to clear all dishwasher instead of presoaking them in the sink. When you
options and cycles.select Soak & Scour, the dishwasher fills and then sprays for
8 minutes. It will then pause for 16 minutes while dishes soak,
and then spray for 90 seconds to keep dishes wet. Pausing for
Changing a Cycle or Setting16 minutes and spraying for 90 seconds are repeated for 4 hours.
At the end of the 4 hours, the dishwasher drains and then starts
During the first fill of a cyclethe cycle you have selected. The Main Wash heating time will be
extended to allow the water temperature to reach 145°F (63°C).
1. Press a new cycle and/or options.This presoaking uses only one additional fill of water and does
2. Check the detergent dispensers. They must be filled properly not require special detergent. Use standard detergent according
to cycle recommendations.
for the new cycle.
3. Press START/RESUME.
Hi-Temp Wash
After the first fill of a cycleSelect this option to increase the target water temperature during
the wash portions of the cycle. Hi-Temp Wash raises the target
1. Press CANCEL/DRAIN. Your dishwasher starts a 2-minute water temperature to 145oF (63oC) in the main wash. Heating the
drain, if needed, and clears all indicators.
water helps improve washing results. Hi-Temp Wash is useful
NOTE: If your dishwasher does not need draining, the when loads contain baked-on food.
dishwasher stops and clears all indicators.This option adds heat, wash time and water to the cycle.
2. Check the detergent dispensers. They must be filled properly NOTE: Hi-Temp Wash is an option with Pots & Pans and Normal
for the new cycle.cycles. Selecting Hi-Temp Wash with the Sani Rinse option has
3. Press a new cycle and/or options.no effect, as it already raises the main wash to 145°F (63°C).
4. Press START/RESUME. (The door must be closed.)
Sani Rinse
Adding Items During a CycleSelect this option to raise the water temperature in the final rinse
You can add an item anytime before the main wash starts. Open to approximately 155°F (68°C). The Sani Rinse option adds heat
the door and check the detergent dispenser. If the cover is still and time to the cycle. The Main Wash heating time will be
closed, you can add items.extended to reach 145°F (63°C). In the Pots & Pans and Normal
cycles, this high-temperature rinse sanitizes your dishes and
To add itemsglassware in accordance with NSF/ANSI Standard 184 for
Residential Dishwashers. Certified residential dishwashers are
not intended for licensed food establishments.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.NOTE: Use the Sani Rinse option with Pots & Pans and Normal
2. Open the door. If the detergent dispenser cover is still closed, cycles. Only these sanitization cycles have been designed to
add the item.meet the NSF/ANSI requirements.
3. Close the door firmly until it latches.
4. Press START/RESUME. The dishwasher resumes the cycle Heated Dry
after a 5-second pause.Select this option to dry dishes with heat.
Switching off Heated Dry skips the dry period. This is useful when
loads contain plastic dinnerware that may be sensitive to high
temperatures. The dishes take longer to dry and some spotting
may occur. Some items (such as plastics) may need towel drying.
For best drying, use a liquid rinse aid.
NOTE: Heated Dry is an option with all cycles, except GLASS
XPRESS? and Rinse Only cycles. Heated Dry begins
automatically with all cycles unless you switch it off.
14 |
ACEC
