Operating Instructions
Continued
8400 Series Models Cycle control knob
Starting your dishwasher To add a dish after starting
1. Select a drying option. (See page 6.) The 1. To be sure that added item is washed and
indicator above the button will show red when rinsed, make sure the Cycle Control Knob has
that option has been selected. not passed LIGHT WASH.
NOTE: Select AIR DRY for the Rinse 8 Hold 2. Lift up on the door latch to unlatch door and
Cycle. stop the cycle. Don?t open the door until the
For the 8300 series models, the Heat Dry spray arms stop spinning.
Option is automatically selected with the Pots 3. Open the door and add the dish.
& Pans Cycle. 4. Close the door. Do not latch it. Wait 30
2. For the 8300 series models, if the Pots 8 seconds for air in the dishwasher to warm up.
Pans Cycle will be used, push the POTS & This helps reduce the amount of moisture that
PANS button. The indicator above the button can come from the vent when restarting the
will show red. cycle.
For the 8400 series models, push a Cycle 5. Press door in to latch it. This dishwasher will
Selector button for the desired cycle. Normal start where it stopped.
Wash, Light Wash and Rinse & Hold Cycles
share the same button. The Cycle Control Knob
determines which cycle operates. Changing a cycle setting
3. Turn the Cycle Control Knob clockwise to point You can change a setting anytime during
to a desired cycle. You will feel a definite stop at any cycle.
each cycle mark. The dishwasher will automati-
cally start the cycle you selected. 1. Lift up on the door latch to unlatch the door
NOTE: If the door is latched, you will hear cycles and stop the cycle.
2. Turn the Cycle Control Knob clockwise to the
start and stop as the knob passes each cycle cycle you want.
mark. This is normal and will not hurt the dish-
washer. If you prefer, you can set cycles with the 3. Be sure the detergent dispensers are filled
door unlatched. properly for the new cycle. When changing dial
from LIGHT WASH to NORMAL WASH or
POTS & PANS setting, detergent is released.
Reload covered section of dispenser before
starting Normal Wash Cycle or Pots & Pans
Cycle.
4. Close and latch the door. The dishwasher will
automatically start the new cycle. |
ACEC
