Cycle Selection ChartUse this cycle for pre-Use
rinsed or lightly soiled covered
For Series 400, 800, 801, 805, 810 and 811:LIGHT
loads.detergent
Turn the Cycle Control knob to the desired cycle.
WASHdispenser
For Series 840:section.
Press the desired cycle. Turn the Cycle Control knob to the
desired cycle. If the door is latched, you will hear the cycles start
and stop as the Cycle Control knob passes each cycle mark. This WashRinseRinseMainRinseFinal DryTimeWater
WashRinse(min)Usage
is normal and does not hurt the dishwasher. If you prefer, you can
(gal/L)
set the Cycle Control knob with the door unlatched.
855.7/21.8
NOTE: Normal Wash, Light Wash and Rinse Only all share the llllllllllllllllllll
same cycle button.
For Series 850 and 890:
Press the desired cycle. Turn the Cycle Control knob to the
desired cycle. If the door is latched, you will hear the cycles start Use this cycle for rinsing Do not use
and stop as the Cycle Control knob passes each cycle mark. This dishes, glasses, and detergent
is normal and does not hurt the dishwasher. If you prefer, you can silverware that will not be with this
set the Cycle Control knob with the door unlatched.washed right away.cycle.
To use Rinse Only, press Normal or Light and turn the Cycle
Control knob to RINSE ONLY.
WashRinseRinseMainRinseFinal DryTimeWater
WashRinse(min)Usage
A ?l ? shows what steps are in each cycle. Your model may have
(gal/L)
some or all of the cycles shown.
202.9/10.9
Water usage is shown in U.S. gallons/liters.llllllll
Cycle time includes dry time.
Canceling a Cycle
You can cancel a cycle at any time.
1. Turn the Cycle Control knob slowly clockwise until you hear
Use this cycle for hard-to-Use both
water draining. Let the dishwasher drain completely.
clean, heavily-soiled pots, detergent
2. Open the door.
pans, casseroles, and dispenser
regular tableware.sections.3. Turn the Cycle Control knob to OFF.
WashRinseRinseMainRinseFinal DryTimeWater Changing a Cycle or Setting
WashRinse(min)Usage
(gal/L)
(On some models)
988.6/32.7
llllllllllllllllllllllllllllIf your dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the Cycle Control knob clockwise.
Use this cycle for loads Use both
3. Check the detergent dispensers. They must be filled properly
with heavy food soil.detergent
for the new cycle.
dispenser
sections.NOTE: Turning the Cycle Control knob can cause the covered
Detergent Dispenser section to open and release the
detergent. Check the covered section if the cycle uses
WashRinseRinseMainRinseFinal DryTimeWater detergent in both sections.
WashRinse(min)Usage
(gal/L)4. Close the door firmly until it latches. The dishwasher starts a
988.6/32.7new cycle.
llllllllllllllllllllllllllll
Adding Items During a Cycle
Use this cycle for loads Use both (On some models)
with normal amounts of detergent You can add an item anytime before the main wash starts, or the
food soil. (The energy-dispenser Cycle Control knob reaches Light Wash.
usage label is based on sections.
1. Lift up the door latch to stop the cycle. Wait for the spraying
this cycle.)
action to stop before opening the door.
WashRinseRinseMainRinseFinal DryTimeWater 2. Open the door and add the item.
WashRinse(min)Usage
3. Close the door, but do not latch it. Wait 30 seconds for the air
(gal/L)
in the dishwasher to warm up. This reduces the amount of
907.2/27.2
llllllllllllllllllllllll moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
13 |