,
Before starting your dishwa .sher
(~~?1?1?1?1?1?1?1?11?1111111111111
1. Read ?Important Safety Instructions? on page
2 before starting your dishwasher.
2. Spin the Upper and Lower Spray Arms to
make sure nothing will stop them from turning
freely.
3. Push door firmly when closing and it will auto-
matically latch.
4. Run hot water at sink nearest dishwasher until
it is hot. Turn it off.
Starting your dishwasher CLEAN SELECTOR BUllONS OPTION SELECTC
1. Push a Clean Selector Button for the desired -POTS & PANS and HEAVY WASH Cycles share
cycle. the same spot on the dial. The Clean Selec-
2. Push Option Selector Button for desired option tor Button determines which cycle it
or options. (Use AIR DRY for RINSE & HOLD operates.
Cycle.] - NORMAL WASH, LOW ENERGY WASH and
3. Turn Cycle Control Knob clockwise to point to RINSE & HOLD Cycles share the NORMAL
a desired cycle.You will feel a definite stop at WASH Clean Selector Button. The Cycle
each cycle mark. Control Knob setting determines which cy-
cle will operate.
The dishwasher will automatically start the
selected cycle.
The AIR DRY Option
Air in the dishwasher is automatically heated night] and some water spotting may result.
during the ?dry? pari of all cycles. Some items (such as plastics) may need towel
If the AIR DRY Option is selected, air in the drying.
dishwasher is not heated. Using this option helps For best results, use a liquid rinse aid such as
save energy, but dishes take longer to dry (over- Jet-Dry.8
HI-TEMP WASHING Option
When this option is selected, water for the If water is already hot enough, the cycle
main wash and the final rinse is heated (except continues without delay. The WATER HEATING
in RINSE & HOLD] to 145°F (63°C). Washing and HOLD Signal Light will be on while the cycle
rinsing action in those parts of the cycle will delays for water heating.
be longer if the water is heated. HI-TEMP wash-
ing is automatic in POTS & PANS.
Changing a setting
You can change a setting anytime during any 3. Be sure the detergent dispensers are filled
cycle. properly for the new cycle.
1. Lift up on the door latch to unlatch the door 4. Press door firmly to latch it. The dishwasher
and stop the cycle. Don?t open the door until will automatically start the new cycle.
the spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
To add a dish after starting
1. To be sure the added item is washed and 4. Close the door. Do not latch it. Wait 30 sec-
rinsed, make sure the ADD A DISH Signal Light onds for air in the dishwasher to warm up. This
is ON. helps reduce the amount of moisture that
2. Lift up on the door latch to unlatch the door can come from the vent when restarting the
cycle.
and stop the cycle. Don?t open the door until
the spray arms stop spinning. 5. Latch the door. The dishwasher will start from
where it stopped.
3. Open the door and add the dish.
8 |
ACEC
