REFRIGERATOR USE
Using the Controls
Turning Refrigerator On
WARNING
If the refrigerator is not on, press COOLING ON/OFF to turn
the cooling on.
To turn your refrigerator off, press COOLING ON/OFF. Your
refrigerator will not cool when the control is set to Off.
NOTE: Pressing the Cooling On/Off button does not
disconnect power to the refrigerator. The interior lights will
Electrical Shock Hazardturn off if either compartment door is open for more than
10 minutes. Simply close and open the door to turn on the
Plug into a grounded 3 prong outlet.interior lights.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Viewing Set Points
NOTE: Make sure the refrigerator is plugged into a grounded
3prong outlet.
The factory recommended set points are 0°F (-18°C) for the
The control panel is located in the top of the refrigerator
freezer and 37°F (3°C) for the refrigerator.
compartment. To view or adjust the controls, push up on the
control panel and release. Set point range for the freezer: -6° to 6°F (-21°C to -14°C)
Set point range for the refrigerator: 32° to 46°F (0°C to 8°C)
To view the set point temperatures, press either the up or down
button for the refrigerator or freezer temperature. The display will
become brighter to indicate that you are viewing the set points.
Five seconds after an adjustment is made, the display lights will
dim and return to the actual temperature.
NOTE: During automatic defrost cycles, the actual temperature
displayed may be higher than the set point. This is normal. The
actual temperatures should return to the set points within a few
hours following completion of the defrost cycle.
For your convenience, your refrigerator controls are preset at the
factory. When you first install your refrigerator, make sure that the Adjusting Controls
controls are still preset to the mid-settings as shown.
The mid-settings indicated in the previous section should be
correct for normal household refrigerator usage. The controls are
set correctly when milk or juice is as cold as you like and when ice
cream is firm.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not blocked.
If you need to adjust temperatures, use the settings listed in the
chart below as a guide. Wait at least 24 hours between
IMPORTANT: adjustments.
The refrigerator control adjusts the refrigerator compartment
temperature. The freezer control adjusts the freezer CONDITION/REASON:ADJUSTMENT:
compartment temperature.
REFRIGERATOR too warmREFRIGERATOR
The displays normally show the actual temperature inside the
Control 1° lower
refrigerator and freezer. For information on displaying set point
temperatures, see ?Viewing Set Points.?FREEZER too warm/too little iceFREEZER Control 1°
Wait 24 hours before you put food into the refrigerator. If you lower
add food before the refrigerator has cooled completely, your
food may spoil. REFRIGERATOR too coldREFRIGERATOR
Control 1° higher
NOTE: Adjusting the refrigerator and freezer controls to a
lower (colder) setting will not cool the compartments any FREEZER too coldFREEZER Control 1°
faster.
higher
3 |
ACEC
