6. RUN WATER THROUGH THE DISPENSER UNTIL THE
WATER RUNS CLEAR (about 2 - 3 gallons or 6 - 7 minutes).
This will clean the system and clear air from the lines. Refrigerator Shelves
Additional flushing may be required in some households.The shelves in your refrigerator are adjustable to meet your
NOTE: As air is cleared from the system, water may spurt out individual storage needs. Your model may have glass or wire
shelves.
of the dispenser.
Storing similar food items together in your refrigerator and
Using the dispenser without the water filteradjusting the shelves to fit different heights of items will make
You can run the dispenser without a water filter cartridge. Your finding the exact item you want easier. It will also reduce the
water will not be filtered. If you run the dispenser without a water amount of time the refrigerator door is open, and save energy.
filter cartridge, keep the cartridge cap and replace it in the base
IMPORTANT: Do not clean glass shelves with warm water when
grille for future use.they are cold. Shelves may break if exposed to sudden
1. Remove the base grille water filter cartridge (See ?Changing a
temperature changes or impact, such as bumping. For your
base grille water filter cartridge? earlier in this section.) Then protection, tempered glass is designed to shatter into many small
slide the cartridge cap off the end of the filter cartridge. DO
pebble-size pieces. This is normal.
NOT DISCARD THE CAP. NOTE: Glass shelves are heavy. Use special care when removing
2. With the cartridge cap in the vertical position, insert the cap
them to avoid impact from dropping.
into the base grille until it stops.
Slide-out Shelves (on some models)
nTo slide out shelf, carefully pull front of shelf toward you.
nTo slide in shelf, push shelf in until it stops.
3. Rotate the cartridge cap to a horizontal position as shown in
step 5.
To remove and replace a shelf in a metal frame:
NOTE: The cartridge cap may not be even with the base
grille.1. Pull the shelf forward to the stop.
2. Tilt the front of the shelf up and lift it slightly as you pull the
shelf from the frame.
Interior Water Filtration System
3. Replace the shelf by guiding it back into the slots on the
(on some models)frame and pushing the shelf in past the stop.
The interior water filter cartridge is located in the upper right-Shelves and Shelf Frames
hand corner of the fresh food compartment of the refrigerator. To remove and replace a shelf/frame:
The interior water filter cartridge should be replaced every six
1. Remove the shelf/frame by tilting it up at the front and lifting it
months or earlier if the flow of water to your water dispenser or out of the shelf supports.
ice maker decreases noticeably.
2. Replace the shelf/frame by guiding the rear shelf hooks into
Replacing the interior water filter cartridgethe shelf supports. Tilt the front of the shelf up until rear shelf
1. Twist the interior water filter cartridge 6.RUN W13TER THROUGH THE A DISPENSER UNTIL THE turn to the left. The hooks drop into the shelf supports.
INSTALL mark will be lined up with the indicator mark located
on the filter mounting bracket cover.3. Lower the front of the shelf and check to make sure that the
shelf is securely in position.
2. Gently pull down on the cartridge to remove it from the filter
mounting bracket assembly. To prevent water from spilling
inside the refrigerator, DO NOT TIP the cartridge.
3. Dispose of the cartridge.
4. To install a new cartridge, refer to ?Installing the interior water
filter cartridge? section in this Use and Care guide.
NOTE: You can run the dispenser without a water filter cartridge.
Your water will not be filtered.
13 |
ACEC
