Before Using Your
Refrigerator
In This Section
Page Page
Cleaning it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installing it properly . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Plugging it in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Leveling it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning it
Removing packaging materials NOTE: Do not remove any permanent
*. -
instruction labels inside your retngerator. uo
Remove tape and any inside labels (except
the model and serial number label) before not remove the Tech Sheet fastened under
using the refrigerator. the refrigerator at the front.
To remove any remaining glue: Cleaning it before use
l Rub briskly with thumb to make a ball, then After removing all packaging materials,
remove. clean your refrigerator before using it, if
OR necessary. See cleaning instructions on
l Soak area with liquid hand-dishwashing pages 23-24.
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See ?Important
Safety Instructions? on page 3.
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
grounding
See Electrical Requirements and Ground-
PlKI
ing Instructions Sheet in your Literature
Package.
5 |
ACEC
