TIPS
*The dispensers will work only with the freezer l Ice can shrink. Cold moving air slowly evapo-
door closed. rates them. If you use ice often, you may never
notice the change.
aThe ice dispenser will work only if the bin is
pushed all the way in. . Good water quality is important for good ice
quality. It is not recommended that the ice
muse only ice crescents from the ice maker. maker be connected to a softened water supply.
Other shapes won?t dispense properly.
*When you need more ice than a glass or two, Water softener chemicals such as salt from a
malfunctioning softener can damage the ice
scoop it from the bin or remove the bin. The dis- maker mold ana lead to poor quality ice. If a
penser motor may stop if the dispenser bar is softened water supply cannot be avoided, then
held in too long. It will be ready to run again in
it is important that the water softener be well
about 3 minutes. maintained and operating properly.
l Ice stored too long can go stale...like water.
Throw it away.
Plan to remove and empty the storage bin:
l If the ice dispenser has not, or will not be used for a
week or more;
9 If a power failure causes ice in the bin to melt and
freeze together;
l If the ice dispenser is not used regularly.
1. Pull the coverino oanel out from the bottom and
slide it to the rear:
2. Lift the signal arm so it clicks into the OFF posi-
tion. Ice can still be dispensed, but no more will be
made.
Night Light S
3. Lift the front of the storage bin. Pull it out.
4. Empty the bin. Use hot or warm water to melt the
ice if necessary. Never use anything sharp to
break up ice in the bin. This can damage the bin
The night light uses a heavy-duty 1 O-watt bulb. When
and dispenser mechanism. it burns out, purchase another from your dealer.
5. Wash with mild detergent. Rinse well. Do not use
harsh or abrasive cleansers or solvents.
6. When replacing the bin, make sure it is pushed
in all the way. Push the signal arm down to the
ON position to restart ice production. |
ACEC
