Install properly.. .
Remove sales labels.. .
Remove the Consumer Buy Gurde label and other
Inside labels before using the refrigerator. Any glue
left can be taken off with rubbing alcohol.
Clean it.. .
Clean your refrigerator before using it. See clean-
I, Allow ?/2? (2 cm) space on each side and at top for ing instructlons on pagell.
ease of installatron.
2. The refrigerator back can be flush against the
wall.
3. If the refrigerator is to be in a corner, keep IV4
inches (3.1 cm) between the wall and side of the Plug it in...
refrigerator so there is room to open the
SERVA-DOOR? or to clear the ice and water 3-prong
dispenser. grounding type
wall receptacle
Level refrigerator-freezer.. .
Front Roller
Front Roller
Refrigerator
Power Cord
Recommended
Grounding Method
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended that
a separate circuit serving only this appliance
be provided.
Right to Raise; Do not use an extension cord. Use a receptacle
which cannot be turned off with a switch or pull
Lett to Lower
chain. See individual electrical requirements and
1, Remove base grille (see page 10 ) grounding instruction sheet in your literature
2. To raise front, turn each screw to the right. package.
3. To lower front, turn each screw to the left.
4. Check with level.
4 |
ACEC
