Electrical RequirementsBase Grille
WARNING
To remove the base grille:
Electrical Shock Hazard1. Open both refrigerator doors.
Plug into a grounded 3 prong outlet.2. Place hands along the ends of the grille, with your thumbs
along the top. Push in with your thumbs and pull up on the
Do not remove ground prong.bottom.
Do not use an adapter.NOTE: Be sure to refasten the Tech Sheet behind the base grille
after cleaning.Do not use an extension cord.
Failure to follow these instructions can result inTo replace the base grille:
death, fire, or electrical shock.1. Open the doors.
2. Line up the grille support tabs with the metal clips.
Before you move your refrigerator into its final location, it is 3. Push the grille firmly to snap it into place.
important to make sure you have the proper electrical
connection:
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the control (Thermostat, Refrigerator
or Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting.
5 |
ACEC
