Water Filtration System
Do not use with water that is microbiologically unsafe or of Changing the Water Filter
unknown quality without adequate disinfection before or
after the system.1. Press the eject button to release the filter from the base grille.
2. Pull the filter straight out.
3. Turn the cap counterclockwise to remove it from the filter.
Water Filter Status Light (on some models)IMPORTANT: Do not discard the cap. It is part of your
The water filter status light will help you know when to change refrigerator. Keep the cap to use with the replacement filter.
your water filter. When the water filter status display changes 4. Align the ridge on the cap with the arrow on the new filter and
from ?GOOD? to ?ORDER,? this tells you that it is almost time to turn the cap until it snaps into place.
change the water filter cartridge. Replace the water filter NOTE: You can run the dispenser without a filter. Your water
cartridge when the water filter status display changes to will not be filtered. Simply insert the cap all of the way into the
?REPLACE.? If water flow to your water dispenser or ice maker base grille and rotate the cap until it is firmly in place.
decreases noticeably, change the filter sooner. The filter should
5. Remove the protective covers from the O-rings. Be sure the
be replaced at least every 6 months depending on your water O-rings are still in place after the covers are removed.
quality and usage.
After changing the water filter, reset the status light by pressing 6. Push the filter into the base grille. The eject button will pop
and holding the FILTER button for 3 seconds. The status light will back out when the filter is fully engaged.
change from ?REPLACE? to ?GOOD? when the system is reset.7. Flush the water system. See ?Water and Ice Dispensers.?
REFRIGERATOR CARE
3. Wash stainless steel and painted metal exteriors with a clean
Cleaningsponge or soft cloth and a mild detergent in warm water.
4. There is no need for routine condenser cleaning in normal
home operating environments. If the environment is
WARNINGparticularly greasy or dusty, or there is significant pet traffic in
the home, the condenser should be cleaned every 2 to
3 months to ensure maximum efficiency.
If you need to clean the condenser:
 Remove the base grille.
 Use a vacuum cleaner with a soft brush to clean the grille,
the open areas behind the grille and the front surface area Explosion Hazard
of the condenser.
Use nonflammable cleaner. Replace the base grille when finished.
Failure to do so can result in death, explosion, or fire.5. Plug in refrigerator or reconnect power.
Both the refrigerator and freezer sections defrost automatically. Changing the Light Bulbs
However, clean both sections about once a month to avoid
buildup of odors. Wipe up spills immediately.NOTE: Not all bulbs will fit your refrigerator. Be sure to replace
the bulb with one of the same size, shape and wattage.
IMPORTANT: Because air circulates between both sections, any Replacement bulbs are available from your dealer.
odors formed in one section will transfer to the other. You must  The dispenser lights are LEDs that can not be changed.
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly. All other lights require a 40-watt bulb.
To Clean Your Refrigerator:1. Unplug refrigerator or disconnect power.
NOTE: Do not use abrasive or harsh cleaners such as window 2. Remove light shield when applicable.
sprays, scouring cleansers, flammable fluids, cleaning waxes, NOTE: To clean the light shield, wash it with warm water and
concentrated detergents, bleaches or cleansers containing liquid detergent. Rinse and dry the shield well.
petroleum products on plastic parts, interior and door liners or 3. Remove light bulb and replace with one of the same size,
gaskets. Do not use paper towels, scouring pads, or other harsh
cleaning tools.shape and wattage.
4. Replace light shield when applicable.
1. Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior 5. Plug in refrigerator or reconnect power.
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
8 |
ACEC
