INSTALLATION INSTRUCTIONS
NOTE: It is recommended that you do not install the refrigerator
near an oven, radiator, or other heat source. Do not install in a
Unpack the Refrigerator
location where the temperature will fall below 55°F (13°C).
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
1/2" (1.25 cm)
Failure to do so can result in back or other injury.
Remove packaging materials. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the surface of your
refrigerator. For more information, see ?Refrigerator Safety.?
When Moving Your Refrigerator:
2" (5.08 cm)
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving it. Electrical Requirements
Do not wiggle or ?walk? the refrigerator when trying to move
it, as floor damage could occur.
WARNING
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Electrical Shock Hazard
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass Plug into a grounded 3 prong outlet.
shelves and covers are heavy. Use special care when
Do not remove ground prong.
removing them to avoid impact from dropping.
Do not use an adapter.
Do not use an extension cord.
Location RequirementsFailure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
Explosion Hazard
NOTE: Before performing any type of installation, cleaning, or
Keep flammable materials and vapors, such as
removing a light bulb, turn the control (Thermostat, Refrigerator or
gasoline, away from refrigerator.Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you
Failure to do so can result in death, explosion, or fire.
are finished, reconnect the refrigerator to the electrical source and
reset the control (Thermostat, Refrigerator or Freezer Control
To ensure proper ventilation for your refrigerator, allow for 1D?" depending on the model) to the desired setting.
(1.25 cm) space on each side and at the top. When installing your
refrigerator next to a fixed wall, leave 2" (5.08 cm) minimum on
each side (depending on your model) to allow for the door to
swing open. If your refrigerator has an ice maker, allow extra
space at the back for the water line connections.
3 |
ACEC
