The interior light...
WARNING: To avoid possible shocks, first unplug
freezer or turn off electricity leading
to freezer at the main power supply.
To replace:
I, Remove the light bulb.
2. Replace bulb with a 15.watt appliance bulb
3. Plug in power cord or switch on electricity
The signal light...
automatically warns of any unexpected power To replace:
failure. I, Unplug power cord from outlet.
If the signal light is not glowing, Immediately check: 2. Carefully snap out light cover and assembly with a
l for power interruption, screwdriver by inserting it under the end of metal
l for an unplugged power cord, edge of the light, Be careful not to chip finish on
l for a burned out signal light. freezer
I 3. Unplug burned out signal light and replace with a
new one. Signal light can be ordered from your
WHIRLPOOL dealer,
4. Then, snap light assembly into place.
5. Plug power cord into outlet.
Energy saving tips... l Fill to capacity Follow recommended procedures
l Check lid gasket and level cabinet to ensure a for freezing foods.
good lid seal. Keeping freezer locked ensures Ird l Set Temperature Control to provide temperatures
closure. around 0°F ( - 17,8?(Z). There is no need to store foods
l Keep lid openings to a minimum Remove several below 0°F.
items at one time. Keep contents organized to elimr- l Do not let frost build up to more than Y4 Inch
nate searching. (6 mm) fhlck.
Cleaning your freezer
This freezer should be cleaned when frost has built up to about Y4 inch (6 mm] thickness
Complete defrosting and cleaning should be done at least once a year.
In high humidity areas, a freezer may need more frequent defrosting.
To defrost and clean:
I. Unplug freezer.
2. Take out all frozen food and sliding baskets.
NOTE: Wrap frozen foods and packages in several
layers of newspaper and cover with a blanket. Food
will stay frozen several hours.
3. Remove drain cover by pulling out.
4. Insert hose adapter provided into drain outlet.
After defrosting:
5. Remove rubber stopper from inside bottom of
freezer. 1, Remove hose adapter.
6. Place a pan under the drain, or attach a hose to the 2. Replace drain cover and rubber stopper.
threaded end of the adapter and direct water into 3. Plug in freezer.
a separate drain. 4. See directions for ?Setting the Temperature Con-
7. Clean freezer according to the following trol:? page 5.
directions. |
ACEC
