Before using your freezer, you are personally l is not near an oven, radiator or other heat
responsible for making sure that it...
source.
l is installed and leveled on a floor that will l is properly maintained.
hold the weight, and in an area suitable for l is in a dry sheltered area.
its size and use.
l is used in an area where the room tempera-
l is connected only to the right kind of outlet, ture will not exceed 110°F (43.3?C).
with the right electrical supply and ground-
l is not run where there are explosive fumes.
ing. (Refer to your ?Electrical Requirements
and Grounding Instructions:?) l is not used by children or others who may not
understand how it should be used.
l is used only for jobs expected of home
freezers. l is not loaded with food before it has time to
get properly cold.
Install Properly. . . Remove Sales Label.. .
Remove the Consumer Buy Guide label before
using the freezer. Remove any left over glue with
rubbing alcohol.
Note: DO NOT REMOVE the Care and Ser-
vice label on the inside lid. This permanent
label provides immediate information
Allow room tooDen lid 1
should it be needed. Do not remove Tech
Sheet permanently attached to back of
cabinet.
I
Clean It...
Clean your freezer before using it. See clean-
ing instructions on page 4.
Defrost Drain Cover...
Installing Defrost Drain Cover:
1. Remove cover from literature package.
Check the strength of the floor. It should hold 2. Check drawing on page one for placement.
weight of fully loaded freezer.
3. Install cover.
Allow at least 3 inches (7.5 cm] air space on
all sides of freezer and 2 inches (5 cm) at J-prong groundlng
Plug It In...
back. Leave room at top for lid to open all the type wall receptacle? Ilrdl g?b
way.
It should not be necessary to remove the lid
during installation. If. for any reason, the hinges
need adjustment, see your authorized
WHIRLPOOL dealer.
Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
groundlng plug
power cord
B
Recommended Groundlng Method
level Chest Freezer.. .
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused
from end to end and front to back so that the Ild
electrical supply is required. It is recommended
WIII seal properly
that a separate circuit serving only this appliance
Check with level be provided. The receptacle should not be con-
trolled by a wall switch or pull chain.
Attach retaining clip over power cord plug from
the literature package inside your freezer. Do not
use an extension cord. |
ACEC
