Electrical RequirementsDoor Handle Installation and Removal
Tools Needed: Flat-blade screwdriver
WARNING
1
2
3
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in2
death, fire, or electrical shock.1
Before you move your refrigerator into its final location, it is1.Handletrim
important to make sure you have the proper electrical2.Handlescrews
connection.3.Doorhandle
1. Place the handle on the door as shown.
2. Using a flat-blade screwdriver, attach the handle to the door
with the 4 handle screws (provided).
3. Place the trim pieces on the upper and lower handle ends as
Recommended grounding methodshown.
NOTE: Some models have an (optional) gold trim piece that
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, groundedsnaps on the handle ends before placing the end trim pieces.
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet4. Apply firm pressure with your hand on the face of the trim.
that cannot be turned off by a switch. Do not use anSlide the top trim down and the bottom trim up toward the
extension cord.handle.
NOTE: Before performing any type of installation, cleaning, or5. To remove the handle, reverse these directions.
removing a light bulb, turn the Temperature Control to the off
position as shown and then disconnect the refrigerator from the
electrical source.Door Closing
NOTE: Keep the 2 bolts that secured the refrigerator in the
shipping case. They are the front leveling legs.
Your refrigerator has 2 adjustable leveling legs. If your refrigerator
seems unsteady or you want the doors to close easier, adjust the
refrigerator's tilt using these instructions.
1. Screw the legs all the way into the bolt holes in the bottom
corners of the refrigerator.
2. Plug into a grounded 3 prong outlet.
3. Move the refrigerator into its final position.
When you are finished, reconnect the refrigerator to the electrical4. Adjust the front legs just enough to lift the cabinet up off of
source and reset the Temperature Control to the desired setting.the floor.
NOTE: If your model is equipped with rollers, the front legs
should be lowered enough to lift the rollers off of the floor to
ensure the refrigerator does not roll forward when the door is
opened.
5 |
ACEC
