nDepending on your model, do not remove the white
Styrofoam insert that is located behind the control panel on
the ceiling of the refrigerator. The insert is part of the
INSTALLING YOUR
refrigerator and not part of the packing material. If the insert
is removed, ice may migrate down from the freezer and cause
REFRIGERATORicicles to form.
When Moving Your Refrigerator:
Unpacking Your Refrigerator
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving it.
WARNING
Do not wiggle or ?walk? the refrigerator when trying to move
it, as floor damage could occur.
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.Space Requirements
Remove shelves from the shipping position (shelves are
shipped upside down):WARNING
IMPORTANT: Do not clean glass shelves with warm water when
they are cold. Shelves may break if exposed to sudden
temperature changes or impact, such as bumping. For your
protection, tempered glass is designed to shatter into many small
pebble-size pieces. This is normal.
NOTE: Glass shelves are heavy. Use special care when removing
them to avoid impact from dropping.
1. Grasp the front of the upper shelf with one hand and use the
other hand to remove packing material from the shelf area.Explosion Hazard
2. Lower the front of the upper shelf until shelf hooks can be Keep flammable materials and vapors, such as
removed from the shelf supports and pull the shelf forward. gasoline, away from refrigerator.
3. Flip the shelf over and insert the rear shelf hooks into the Failure to do so can result in death, explosion,
shelf supports. Tilt the front of shelf up until rear shelf hooks or fire.
drop into the shelf supports.
4. Lower the front of the shelf and check to make sure that it is nTo ensure proper ventilation for your refrigerator, allow for a
securely in position.
.5 in. (1.25 cm) space on each side
Removing packaging materials
nAllow 3 in. (7.5 cm) of space between overhead cabinets and
nRemove tape and any labels from your refrigerator before refrigerator top.
using (except the model and serial number label).
nAllow at least 1 in. (2.5 cm) between back of cabinet and the
To remove any remaining tape or glue, rub the area briskly
wall.
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
dry.
nDo not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see ?Refrigerator Safety? section.
3" (7.5 cm)
nOn some models, shelves, bins, door shelf rails, and other
feature parts may be packaged in the Interior FeaturePak.
Follow the instructions contained in the package for proper
assembly.
IMPORTANT:
nDepending on your model, do not remove any permanent
instruction labels inside your refrigerator or the Tech Sheet
that is fastened behind the base grille.
2" (5.08 cm)
4 |
ACEC
