Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1. Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoilne, car-
bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the tront.
Clean it.. .
Clean your refrigerator
before using it. See Cleaf
ing instructions on pages
7 and 8.
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm) between the refrig-
erator condenser and the wall.
3. Allow % inch (1.25 cm] on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be Plug it in...
opened wider.
Level refrigerator-freezer...
Refrigerator
Power Cord
RECOMMENDED GROUNDtNG METHOD
This refrigerator has 2 threaded levelling legs that A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
are shipped in a separate package. and properly grounded electrical supply is re-
1. Screw these legs all the way into bolt holes in the quired. It is recommended that a separate circuit
bottom front corners of the refrigerator. serving only this appliance be provided.
2. Slide the refrigerator into place. Do not use an extension cord. Use a recep-
3. Adjust front legs to level the refrigerator. tacle which cannot be turned off with a switch
- To raise corners, turn legs in direction shown. or pull chain. See individual electrical require-
-To lower corners, turn legs in direction shown. ments and grounding instruction sheet in your liter-
4. Check with level. ature package.
4 |
ACEC
