Install properly... Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
SIRIII- S*lrWalCI Iud-IstwIIIW,~ c Ix~myI.lm!mscwm- *wmtmm m3-l
Clean it...
. ator before using
See cleaning in
1. Allow Y2 inch (1.25 cm] space on each side and tions on page 9.
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
es>. _rr- CC1IFhe; v--I-I, IICU?!neAEjlUYnlaGI.x ?El>.*
MS9
Level refrigerator-freezer.. .
Plug it in...
USE SCREWDRIVER 3-PRONG GROUNDIN
TO ADJUST TYPE WALL RECEPTAC
LEVELLING SCREW
REFRIGERATOR 3-PRONG
POWER CORD GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
LEFl TO LOWER
and properly grounded electrical supply is
1. Remove the base grille, (see page 7). required. It is recommended that a separate cir-
cuit sewing only this appliance be provided.
2. To raise front, turn screw in the direction shown.
3. To lower front, turn screw in the direction shown. Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
4. Check with level. pull chain. See individual electrical requirements
5. Replace the base grille, (see page 7). and grounding instruction sheet in your literature
package.
4 |
ACEC
