Reversing the door swing...
You can change the hinges on your refrigerator
so the doors open the other way. You will need a
#20 Torx head screwdriver. Refer to the instruction
sheet included with your refrigerator.
*? _
Removing and adjusting the freezer shelf...>
To remove the shelf:
1. Lift front slightly.
2. Lift back off supports.
3. Replace in reverse order.
To adJust the shelf:
1. Remove shelf.
2. Remove supports by sliding upwards. b
\
3. Replace supports on desired level. SHELF SUPPORT
4. Replace shelf.
,, j ..,
Automatic ice maker...
There are a few things you will want to know You will hear water running when ice maker is
about your automatic ice maker. working. You?ll hear ice fall into the bin. Don?t let
these sounds bother you.
l The ON/OFF lever is a wire signal arm.
The ice maker will not operate until the freezer
Down...for making ice automatically.
is cold enough to make ice. This can take
Up...to shut off the ice maker.
overnight.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
Because of new plumbing connections, the first
NECTED TO THE WATER SUPPLY.
ice may be discolored or off-flavored. Discard
l The dial or lever on the side of the ice maker
the first few batches of ice.
changes the size of the cubes.
If ice is not being made fast enough and more
l Shakethe bin occasionally to keep cubes sepa- ice is needed, turn the Refrigerator Control to-
rated, and to obtain increased storage capacity. ward a higher number. Wait a day and, if neces-
l It is normal for ice crescents to be attached by a sary, turn the Freezer Control toward A.
corner. They will break apart easily. If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
If cubes are stored too long, they may develop
an off-flavor...like stale water. Throw them away.
They will be replaced. Cubes in the ice bin can
also become smaller by evaporation.
Good water quality is important for good ice
quality. It is not recommended that the ice maker
be connected to a softened water supply. Water
softener chemicals such as salt from a malfunc-
tioning softener can damage the ice maker
mold and lead to poor quality ice. If a softened
water supply cannot be avoided,then it is impor-
tant that the water softener be well maintained
and operating properly. |
ACEC
