Removing the base grille
Burn Hazard
Do not touch refrigeration tubes near
defrost pan.
Doing so can result in burns.
To remove the base grille: Condenser coils Defrost pan
1. Open the refrigerator door.
2. Grasp the grille with both hands.
3. Push down on the top edge of the grille to release
the top clips.
4. Tilt the grille toward you to release the bottom clips.
5. Pull grille away from the refrigerator.
NOTE: Do not remove the Tech Sheet fastened behind
the grille.
To replace the base grille:
1. Line up the edges of the grille with the outside edges
of the cabinet.
2. Roll the grille toward you.
3. Place lower clips in the openings in the metal panel.
4. Roll the grille toward the cabinet until the top clips
snap into place.
5. Close the refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 19.
Saving energy
You can help your refrigerator use less electricity. . Go ahead and fill up the refrigerator, but don?t
l Check door gaskets for a tight seal. Level the cabinet overcrowd it so air movement is blocked.
to be sure of a good seal. l It is a waste of electricity to set the refrigerator and
l Clean the condenser coils regularly. freezer to temperatures colder than they need to be.
l Open the door as few times as possible. Think about If ice cream is firm in the freezer and drinks are as
what you need before you open the door. Get every- cold as your family likes them, that?s cold enough.
thing out at one time. Keep food organized so you . Make sure your refrigerator is not next to a heat
won?t have to search for what you want. Close door source such as a range, water heater, furnace,
as soon as food is removed. radiator, or in direct sunlight.
15 |