Install properly... Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any lnslde labels before using the re-
frigerator. To remove any remalnlng glue:
IN-
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
II - STRUCTIONS LABELS INSIDE YOUR REFRIGER-
--
ATOR.
I I Do not remove the Tech sheet fastened under
the retrlgerator at the tront.
Clean it...
Clean your refriger-
a ator before using it.
See cleaning instruc-
tions on page8. ,
1. Allow 3 inches (7.5 cm] between overhead cab-
inets and refrigerator top.
2. Allow at least an inch (2.5 cm) between the re-
frigerator condenser on the back and the wall.
3. Allow YZ inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
Plug it in...
Level refrigerator-freezer.. .
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
USE SCREWDRIVER
TO ADJUST
II
LEVELLING SCREW RAISE h
J
REFRIGERATOR J-PRONG
POWER CORD GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
1. To raise front, turn each screw to the right A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
2. To lower front, turn each screw to the left.
required. It is recommended that a separate cir-
3. Check with level.
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned ott wlth a swttch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.
4 |
ACEC
