Storage Drawer
The storage drawer can be removed. Before removing, make sure To Replace:
drawer is cool and empty.1. Lift up the back of the drawer and place it inside the range in
its fully forward position.
To Remove:
2. Lift up the front of the drawer to a level position.
1. Pull the storage drawer straight back past the drawer stop
3. Slowly push the drawer into the range until the drawer side
notch and the end of the side rails.
rails engage with the gap in the drawer glides.
A
B
A
A.Drawer stop notchA.Engage drawer glide
B.End of side rail
4. Once the drawer is fully engaged on both sides, slide the
2. Lift up the back of the drawer and pull the drawer out.
drawer back into the closed position.
NOTE: When removing and replacing the storage drawer, a
slight push may be needed to move the drawer stop notch
past the drawer glides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operateCooktop cooking results not what expected
Is the power supply cord unplugged?Is the proper cookware being used?
Plug into a grounded outlet.See ?Cookware? section.
Has a household fuse blown, or has a circuit breaker Is the control knob set to the proper heat level?
tripped?See ?Cooktop Controls? section.
Replace the fuse or reset the circuit breaker. If the problem
Is the appliance level?
continues, call an electrician.
Level the appliance. See the Installation Instructions.
On coil element models, is the element inserted properly?
Cooktop will not operate
See ?Coil Elements and Burner Bowls? section.
Is the control knob set correctly?
Push in knob before turning to a setting.Oven will not operate
On ceramic glass models, is the ?Cooktop Lockout? set?
On some models, is the electronic clock/timer set
See ?Cooktop Lockout? section.
correctly?
On coil element models, is the element inserted properly?See ?Electronic Clock/Timer? section.
See ?Coil Elements and Burner Bowls? section.
On some models, has the oven selector been set to a
BAKE or BROIL function?
Excessive heat around cookware on cooktopSee ?Baking and Roasting? or ?Broiling? sections.
Is the cookware the proper size?
Oven temperature too high or too low
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
Does the oven temperature calibration need adjustment?
more than 1" (1.3 cm) outside the cooking area.
See ?Oven Temperature Control? section.
Hot Surface indicator light stays on
Oven indicator lights flash
Does the Hot Surface indicator light stay on after control
Do the OVEN HEATING indicator lights flash?
knob(s) have been turned off?
See ?Assistance or Service? section.
See ?Cooktop Controls? section.
14 |
ACEC
