2. Touch the ?up? or ?down? arrow pads to set the time of day.
COOKWARECHARACTERISTICS
The time can be changed in either small or 10-minute
Porcelain See stainless steel or cast iron.increments by touching a pad briefly or by touching and
enamel-on-holding a pad.
steel or cast
3. Touch CLOCK. The colon will stop flashing when the Clock is
ironactive.
Stainless steelHeats quickly, but unevenly.
Timer
A core or base of aluminum or copper
on stainless steel provides even The Timer can be set in hours and minutes up to 9 hours,
heating.50 minutes, and it counts down the set time. The Timer does not
start or stop the oven.
To Set:
OVEN USE1. Touch TIMER.
The small green light next to the Timer button will flash during
Odors and smoke are normal when the oven is used the first few programming.
times, or when it is heavily soiled.
2. Touch the ?up? or ?down? arrow pads to set length of time.
IMPORTANT: The health of some birds is extremely sensitive to
3. Touch TIMER.
the fumes given off. Exposure to the fumes may result in death to
certain birds. Always move birds to another closed and well Colon will begin flashing, and the Timer will begin counting
ventilated room.down.
To display the time of day while the Timer is counting down,
press CLOCK. Time of day will be displayed until the Timer
Electronic Clock/Timer
button is pressed or until the Timer reaches zero.
(on some models)
When there is one minute of time remaining, the display will
begin counting down in seconds and a ?beep? will sound.
123
When the Timer reaches zero, the display will show ?0:00?
and four short tones will sound. A series of four tones will
sound until the Timer is canceled.
To Cancel: Touch TIMER once in the Timer mode.
Aluminum Foil
IMPORTANT: Do not line the oven bottom with any type of foil,
liners or cookware because permanent damage will occur to the
oven bottom finish.
Do not block or cover the oven bottom vents.
Do not cover entire rack with foil because air must be able to
move freely for best cooking results.
54
To catch spills, place foil on rack below dish. Make sure foil is
1. Timer3. Increase5. Clock
at least 1 in. (2.5 cm) larger than the dish and that it is turned
2. Display4. Decrease
up at the edges.
DisplayPositioning Racks and Bakeware
When power is first supplied to the range, ?12:00? will appear on IMPORTANT: Never place food or bakeware directly on the oven
the display.door or bottom. Permanent damage will occur to the porcelain
If ?12:00? appears at any other time, a power failure has finish.
occurred. Reset the Clock. See ?Clock? section.
RACKS
Any time the Timer is not in use, the display will show the time of
day.Position racks before turning the oven on. Do not move racks
with bakeware on them. Make sure racks are level. For best
performance, cook on one rack. Place the rack so the top of food
Clockwill be centered in the oven. To move a rack, pull it out to the stop
position, raise the front edge, then lift out.
This is a 12-hour clock and does not show a.m. or p.m.
FOODRACK POSITION
To Set:
Before setting, make sure the Timer is off.Frozen pies, large roasts, turkeys, 1 or 2
1. Touch CLOCK. angel food cakes
The colon will flash during Clock programming.
Bundt cakes, most quick breads, yeast 2
breads, casseroles, meats
8 |
ACEC
