Load plastic items so the force of the spray does not move
them during the cycle.EZ-2-Lift? top rack (on some models)
To avoid chipping, do not let stemware touch other items.
You can raise or lower the top rack to fit tall items in either the top
Small bowls, pans, and other utensils can be placed in the or bottom rack. Raise the top rack to accommodate items up to
top rack. Load bowls in the center section for best stability.9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate items up to 11" (28 cm) in
Cup shelves (on some models)both the top and bottom racks. Adjusters are located on each
side of the top rack.
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: The features on your dishwasher may vary from those
shown below.
To raise the top rack
Lift the rack on both sides until the rack is level.
NOTE: The top rack must be level.
To lower the top rack
Depress both tabs on rack adjusters, as shown above, and slide
the rack back to its original position.
Fold-down tines (on some models)
Adjustable 2-position top rack (on some models)
The row of tines on the left-hand and right-hand sides of the top
rack can be folded down to make room for a variety of dishes.You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate items up to 11" (28 cm) in
both the top and bottom racks. Two adjusters are located on
each side of the top rack. Each adjuster has 2 preset positions.
The high and low positions are marked on the adjuster.
To adjust the top rack
1. Hold the top rack with one hand near the adjuster.
To adjust the fold-down tines
1. Grasp the tip of the tine that is in the tine holder.
2. Gently push the tine out of the holder.
3. Lay the tines down, toward the center of the rack.
Light item clips (on some models)2. With the other hand, pull out the top of the adjuster.
3. Raise or lower the rack to one of the preset positions.
The light item clips hold lightweight plastic items such as cups, 4. Release the adjuster.
lids, or bowls in place during washing.
5. Repeat the steps for the remaining adjusters.
NOTE: The top rack must be level.
To move a clip
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
9 |
ACEC
