3. After the washer is in the final location and level, use a yD??"
(14 mm) open-end wrench to turn the nuts on the feet tightly
Secure Drain Hoseagainst the washer cabinet.
1. Drape the power cord over the console.
2. Move the washer to its final location and remove any IMPORTANT: If the nuts are not tight against the washer
cardboard used to move washer.cabinet, the washer may vibrate.
4. Tilt the washer forward until the rear of the washer is at least
3. Locate the beaded tie strap (supplied).4" (10.2 cm) off the floor. You may hear the self-adjusting rear
feet click into place. Lower the washer to the floor.
Complete Installation
1. Check the electrical requirements. Be sure that you have the
Beaded tie strapcorrect electrical supply and the recommended grounding
method. See ?Electrical Requirements.?
4. Wrap the drain hose to the laundry tub leg or standpipe with 2. Check to be sure all parts are now installed. If there is an
the tie strap. (See illustrations A and B.) extra part, go back through the steps to see which step was
skipped.
3. Check to be sure you have all of your tools.
4. Dispose of/recycle all packaging materials. Keep the
expanded foam plug for use if the washer should be
transported.
5. Check to be sure the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
ABC
WARNING
If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe. Tightly
wrap the tie strap around the water inlet hoses and the drain
hose. (See illustration C.)
Do not force excess drain hose back into the rear of the washer.
Level WasherElectrical Shock Hazard
Properly leveling your washer prevents excessive noise and Plug into a grounded 3 prong outlet.
vibration.
1. Check the levelness of the washer by placing a level on the Do not remove ground prong.
top edge of the washer, first side to side, then front to back. Do not use an adapter.
2. If the washer is against a wall, move the washer out slightly Do not use an extension cord.
before tipping back. If the washer is not level, prop up the
front of the washer with the wood block and adjust the feet Failure to follow these instructions can result in death,
up or down as necessary. Repeat this step until washer is fire, or electrical shock.
level.
7. Plug into a grounded 3 prong outlet.
8. Remove the protective film on the console and any tape
remaining on the washer.
9. Read ?Washer Use.?
10. To test your washer, measure 1D? the normal recommended
amount of powdered or liquid High Efficiency detergent and
pour it into the detergent dispenser. Close the lid. Select any
cycle, and then press START. Allow it to complete one whole
cycle.
8 |
ACEC
