Installation Instructions cont.
13.Connect water supply lineNOTE: If you need to remove tubing,
from saddle valve to spout copperpush down on collet. Pull tubing out
water supplytubing with the factory-assembledof quick-connect fitting.
linequick-connect fitting. Push water
quick-connectsupply line tubing straight into fitting
fittingas far as it will go. Pull on tubing.
The tubing should not come out
when properly installed. Turn the
coppersaddle valve handle counterclockwise
tubingto open water line.
saddle
valve
NOTE: Do NOT plug power supply cord into outlet.
14.Turn Temperature Control
counterclockwise to OOff� position.
On
15.Push down and turn the
On/Off Cap clockwise to open spout.
Hold cap open to fill tank (about 1
minute). When tank is full, water will
flow from spout. Release cap.
NOTE: Turn Temperature Control topower supply cord is connected,
OOff� position before plugging hotthe heater will overheat causing
water dispenser into power supplan unpleasant tastey., black specks
If tank is empty and thermostat isin the water, and permanent
in an OOn� position when thedamage to the heater seals.
16.Plug power supply cord intohot water flow from the faucet. This is
grounded outlet.normal for the initial heat-up of the
dispenser.
Turn Temperature Control clockwise
to highest position.Turn Temperature Control to lower
temperature setting if you notice
Water in tank will reach maximum
temperature in approximately vapor or hear boiling noise.
15 minutes.NOTE: Temperature Control
controls tank heater, not water
When water is heating, you may hear
gurgling noises coming from the tank.delivery. Rotate Temperature
There may also be some spitting or Control clockwise to raise water
temperature, countercloise tockw
9lower water temperature. |
ACEC
