INSTALLATION
Remove the transit bolts
1.Slacken the four bolts with the spanner supplied
(Fig. A).
2.Fully unscrew the bolts by hand.
3.Holding the bolt head, pull each bolt with its plastic
spacer through the wide part of the holes (Fig. B).
4.Seal the resulting holes using the plastic caps supplied.
To do this, insert the caps in the wide part of the hole
in the direction of the arrow and push them into the
narrow groove until they click into place (Fig. C).
5.Keep the transit bolts with their plastic spacers for
future use.
Whenever the appliance is transported, the transit bolts Fig. A
must be refitted:
1.Raise the plastic covers with a screwdriver, slide them
in the opposite direction of the arrow and remove.
2.Insert the transit bolts with their plastic spacers,
performing the steps for removal in reverse order.
Fig. B
Fig. C |
ACEC
