Installation
Handle Installation4. Rotate the handle so that the handle
is flat against the door.
If not installed, the handle is located in the interior of
the fresh food section or attached to the back of your5. Grasp the handle firmly and slide
refrigerator.down.
Remove and discard handle packaging and tape.To Remove:
1. Grasp the lower part of the handle
Handle design varies from refrigerator to refrigerator.firmly, slide up, lift and remove from
Please reference the appropriate instructions for your
model below.surface.
Front Mount Handle (select models)Offset Handles
Materials Needed:
To Install:
Y Gloves to protect hands
Y Phillips screwdriver1. Align fresh food handle with trim
Y Plastic door removal card (or 0.1 cm thick plasticretainer and door clip.
card), retain the card for offset handle use.
2. Make sure the tabs of the handle clip
Attach Extensions to Handle: select modelsare below the tabs of the door clip.
1. Align handle and 3. Rotate the handle so that the handle is
extension as shown.flat against the door.
2. Place extension in4. The tab on the lower part of the handle
handle opening.will align with the hole in the handle
3. Apply slight pressure to both sides of thecap.
extension piece.5. Slide handle upward until it clicks.
4. Slide extension until it stops on inside edge of6. Snap top of handle into trim retainer
handle.clip.
7. Repeat for freezer handle.
To Install:To Remove:
1. The handles are to be oriented as1. Protect the area above the handle trim
shown.with tape. Insert the tip of a flat blade
screwdriver between the handle trim
2. Align door handle with the doorand door panel. Carefully pry the trim
studs.
away from the door panel.
3. Ensure the large hole in the2. Pull trim free from the trim retainer.
mounting clip is positioned
downon both ends of the3. Insert door removal card (or 0.1 cm
handle.thick plastic card) between the handle and door
approximately 3.8 cm
Door 4. Grasp the handle firmly and pull downward to
Studremove.
5. Repeat for freezer handle.
4 |
ACEC
