WHIRLPOOL X12002V03 Instruction Manual

Important Safety Starting your air conditioner.
Instructions
1. Set the Exhaust Control? to the
?Closed? position or the Air Control
to the ?Off? position depending on
which feature your air conditioner
Reduce risk of fire, electrical has. This position will provide for
shock or personal injury when maximum cooling.
using air conditioner by following *Consoles shown may vary slightly from
these basic precautions: vour air conditioner. The controls on
jr0u.r air conditioner will operate the
. Complete all of the Installation
same as explained in this section.
Instructions to prevent product
operating problems and possible
personal injury. 2. Set the System Control to the
desired setting. Suggestions are as
m Read all operating instructions
follows:
before using air conditioner.
I Do Not store or use gasoline or Lo Cool - for sleeping comfort
Med Cool - for normal cooling
other flammable vapors and
Hi Cool - for maximum cooling
liquids in the vicinity of this or
Fan Only - for air circulation
any other appliance. The fumes
without cooling.
can create fire hazard or
explosion.
3. Set the Thermostat Control to
. Use only a properly grounded
number 6. You can adjust the
electrical outlet. Check with a
cooling performance by resetting
qualified electrician if you are in
the Thermostat Control to a higher
doubt as to whether the air
number for more cooling or to a
conditioner is properly
lower number for less cooling. You
grounded. Do Not modify the
will need to experiment to find the
plug on the power cord. If it
setting which you prefer.
will not fit the outlet, have a
proper outlet installed by a
qualified electrician.
1 Do Not use an extension cord.
If you turn your air conditioner off,
I Do Not have a fuse in the
wait two or three minutes before
neutral or grounding circuit.
turning it back on. The amount of
time to wait is printed on your
Save these instructions console. You may blow the fuse in
the fuse box or trip the circuit
breaker if you Do Not follow these
instructions.
Using special features.. .
Exhaust Control Exhaust Control
Use this feature to draw stale or smoky air
from the room or to circulate air in the
Room air desired Exhaust Contrc
room. setting
I
See the chart to determine what settings to
Exhaust room air ?Open?
select for the type of air control you desire.
Circulate room air ?Closed
Note: Energy efficiency is decreased when
exhausting room air and cooling at the cooling only ?Closed
I I
same time.
Air Control Air Control
Use this feature to draw stale or smoky air
from the room or to circulate fresh air from
Room air desired Air Conlzol
the outside into the room. I I setting
See the chart to determine what settings to
Exhaust room air ?Exhaust?
select for the type of air control you desire.
Circulate fresh air ?Fresh Air?
into the room
Circulate room air -off
Note: Energy efficiency is decreased when
exhausting room air or circulating fresh air cooling only ?Off
into the room and cooling at the same time.